All right, we're going to remove our air intake horn and our throttle position sensor now
because we're doing all of our driver's side connections of our Juice with Attitude. Removing
the air intake horn and the throttle position sensor are necessary so you can access your
injection pump to tap the pump wire. So three tools to take all this off is all you need.
You need a 10, 11, and a 13 metric socket, deep well. Ten for your hold-down bolts and
your dipstick bolt. Just go ahead and throw that on the concrete.
That's your air intake gasket. Now your throttle position sensor, you're just going to unbolt
it and set it out of your way. Underneath, there's some electrical connectors, and before
you can swing it too far, you've got to get it unhooked. Take it and your grid heater
all in one shot, and simply lay them out of your way.
All right, this is your pump tap wire. It's a gray wire inside of this sheath. The bottom
of the posse tab attaches to the wire. And the wire that you tap is the one that's actually
closest to the block. So when we tap this, what we like to do is turn it backwards four
or five turns. Put a little tension on it. And then, once we attach it to the tap, what
that'll do is that it will unwind naturally and will help you to get the wire started.
All right, so now we've got our pump wire exposed here. We cut our sheath back. And
you want to cut enough of that back to give yourself access so you've got room to work
there, because this is important. Be very careful when you're doing this. Your pump
tap wire is the posse tap that Edge give you in the kit here. And you want to just separate
the bottom side of this, unscrew it, and it actually goes on your pump wire.
We want to turn it to where it's facing up towards you. What we do when we tap the pump
wire is we'll turn the wire, we will unwind the wire opposite of the direction that we're
going to be tightening it, so right tight and left loose, obviously. You just want to
turn it in the opposite direction before you engage the tap. And that'll let it unwind.
That'll let it unwind naturally when you engage the tap, like so. There you go. You just want
to tighten it up finger tight. So there's the pump wire tapped. Now we want to put our
electrical connection back on our VP44. And that's it. You're done at the pump.