Eddie Printer Setup
After unboxing you will find all of the items shown here.
Note: We no longer include sample cookies or icing in the box.
Install the clear top cover aligning the pins with the holes on the top section of the printer.
Install one side and then bend the cover gently to allow the second pin to reach the hole on the opposite side.
Open the top of the printer and remove the foam shipping insert. Keep it along with the other boxing material.
Locate the carousel positioning holes in the base and the pins on the carousel base.
Lift the base of the printer slightly and slide the carousel base underneath. Align the holes with the pins and lower the printer into place.
Locate the 6 Pin Mini Din Cable attached to the Carousel Base.
Route the cable along the left side of the unit until it reaches the back of the printer.
Connect the 6 Pin Mini Din Cable to the round port on the back of the printer.
Locate the Power Supply.
Install the appropriate adapter by aligning the tabs on the plug to the slots in the power adapter.
Rotate the plug until it snaps into place.
Connect the Power Brick to a wall outlet and the round barrel connector to the back of the printer.
Switch on the Printer
Open the Top Cover.
Lift up on the top section of the printer just under the control panel.
Install the Crumb Catcher using the tabs on the front and the hooks on the back as guides.
Let's see that again.
Align the front Crumb Catcher tabs on either side of the Carousel Base connection bracket.
There are hooks on the back that correspond to slots on the back of the printer.
Locate the Carousel Platter. Note the location of the alignment holes and the center hole.
Install the platter by aligning the center hole with center hub on the Carousel Platter base.
Note: The new platter design has triangular alignment pegs.
Install the Edible Ink cartridge.
Push down before closing the lid.
Go to www.primera.com/EddieDownloads to install the software and complete the setup.