Hello, this is the main router
And here is the router NETGEAR
In this video, I show you how to connect a NETGEAR router to another router without a cable
Here are the specific steps
I use a computer that connects the routers one by one and configures them
First of all I configure the main router as follows
While configuring I will write down the necessary information
On the main router you write down the MAC address of the wifi interface
Next, write down the ip address of the main router
I set the router's wifi network name to Router 1 to distinguish between the two routers
On this router you set the wireless channel to 1
In order for two routers to connect without wires, you use the same channel on both routers
Don't forget to set the wifi password of the main router
Now I disconnect between the computer and the main router
Because I will configure the router NETGEAR
The following are the configuration steps on the NETGEAR router
I go to the management page and make sure it doesn't have an internet connection
Here you access advanced settings
Like any other wifi router you set up wireless for it
You name the wifi network and set up a password
For the 2.4 GHz band I named it Router 2
You set the wireless channel to 1 to make sure the two routers have the same frequency
Because this router has two bands, I gave it two different wireless network names
Just like the main router, I will record the necessary information of the second router
I write down the password of the wifi network named Router 2 to use in the next step
I have finished setting up the wireless network name and wireless network password
Next you set the repeater mode for the router NETGEAR
#With this mode NETGEAR router can connect to main router without cable
You write down the wireless MAC address of NETGEAR
Next you create a new ip address for the router NETGEAR
You set this ip address to be different from the ip address of the main router to avoid conflicts
Then you update the main router's MAC address here
You will now lose connection to the NETGEAR router
Here you have completed the configuration on the NETGEAR router
But to connect between two routers you need to set up on the main router as follows
On the main router you write down the MAC address of the wifi interface
After scanning, I found a router with the wireless network name Router 2
This is the NETGEAR router, I will connect Router 1 to Router 2 using repeat mode
On the main router I set WDS to Repeater mode
You can connect NETGEAR router to WDS-enabled routers such as TP-Link, D-Link, Asus
Next you enable the MAC address of the router NETGEAR
Then you set the wireless password set on the router NETGEAR
You apply the above settings and wait a bit for the two routers to connect to each other
Above are the steps to use the NETGEAR router as a repeater
Now I will check the results by connecting to the NETGEAR router using wifi
My NETGEAR router has dual band so I connect to one of its two wifi network names
As you can see, after connecting to the NETGEAR router, my computer has an internet connection
So the NETGEAR router is connected to the main router without cables
Please visit my channel to see more videos
Thanks for watching, don't forget to like and subscribe