Friends, a huge hello to everyone Today we will work with such plexiglass,
or
rather, with its scraps, we will experiment melt it in force, let's see if we can
melt it
. it will be better, the process will be faster
, take a glass container, now we will collect everything and pour
a little more than a quarter
here , about the proportions, I will make the same one more part in
about cups
and pour acetone into the jar in the third cup, close the lid, there is nothing to close the cups Well,
I will use masking tape, seal them tightly and at the same time we sign,
we sign, so as
not
to forget 6 46 the third jar we have acetone, we leave everything And now exactly 24 hours have passed for a
day . there is excess liquid left on top now we will open it quickly and see its contents
such a mass of plastic straight straightened out completely such a very thick one can also
see the same homogeneous mass also the plastic has completely melted also the same mass is homogeneous
thickish Well a little softer than solvents Just generally thick now Let's try
to see how it is liquid plastic will lead Let's just leave it for a day, let's immediately sign that it is 646
solvent so as not to forget Similarly, we glue it with acetone, I want to say very good
soft sticky liquid plastic I also wanted to glue plywood how it behaves on such a coating
very well,
too, we will sign 646
I will not press anything just let's try it as it is, you see, our acetone also stretches and
starts to dry in the air; the glue will also withstand 24 hours;
I'll also try to
glue the plastic; the first one will be a solvent
; I like it better as it is. So
let’s leave it tomorrow and see if it’s already working out. Here, for 44 hours,
the moment has passed since the plastic was poured, so it’s shorter, nothing happened to it, as it was, so there’s not
even a hint that it would melt, there’s no melt, that is, xylene to
this does not suit the case Let's try what we managed to glue MDF
listen How glue but clearly began to speak plastic,
that is, MDF Arsen glue tightly Let's try
the guys glue is really excellent That is, I can’t even with a knife it picks off with another
piece of MDF and then there is no divergence at the seam As you can see, everything is fine, we look at the plywood,
listen Well, the glue is really very good Let's knock the hammer with a
hammer but tore out all the wood, that is, the fibers have dispersed super look now
nothing at all
, yes, you can’t take it at all
about Well, of course this is already a thing now we look that we also had MDF glued on the basis of acetone,
but
it also breaks, in fact,
with acetone the same story is also everything is fine
. place now we'll try to pick it up here
and see how that is, you see it nifiga
tightly glues right tightly here is such a small issue
Write your opinion in the description
See you again bye bye