I used TinkerCad to modify this model from Thingiverse (link in description)
Anycubic Photon 3DPrinter (link in description)
The parts are cleaned and any voids filled with Revell Plasto (or similar) then sanded
Any areas of the finished cast that need to be glossy should be glazed with UV resin
I therefore glazed the top of the trinket box lid and the visor
I hear the Among Us graveyard is overcrowded...
Crewmates are dying to get in XD
Apparently Among Us is now so big, it's going to be re-named HumungUs :O
I told my Doctor I had impostor syndrome...
He told me I was just faking it :/
I use 3mm PVC foamex and a sheet of self adhesive vinyl to create a form around the objects to pour the silicone mouid
Seal all the gaps with hot melt glue
In my last game of Among Us, Crewmates 4, 6, 8 and 10 were killed...
Crewmates 2, 3, 5 and 7 were prime suspects :/
This project used 650g of tin condensation cure silicone
Never use platinum addition cure silicone with UV resin as it will deactivate the catalyst and remain sticky
Slowly drizzle the silicone from a height to encourage any air bubbles to stretch and pop
You can always vacuum de-gas your silicone or cure it under pressure if you have the equipment available
These took about 5 hours at room temperature to cure
I saw a Crewmate killed with a battery...
It was charged with murder XD
A small cut with a sharp knife is needed to remove the legs
When I'm the imposter I just call an emergency meeting and knock them all dead with my jokes :D
To mould an insert for the head, form a coil from wire and suspend it in the cavity using a lolly stick
You may wish to apply a thin layer of Vaseline to help remove the silicone when cured
To cast the bone, I'm using epoxy art resin with Pearl Ex white powder
I use a 3ml pipette to fill the mould from the bottom
After a couple of hours the white resin has thickened up and a layer of blue mica powder can be poured on top for the lid
Use a flame to KILL THE BUBBLES!
I used a dry brush to apply holographic powder directly to the visor area of the mould
The static in the silicone may attract the powder to other areas, which can be removed with a moist cotton bud
For the head and leg moulds I'm using GlassCast 10 casting resin, which can be poured to a deeper depth than my usual art resin
You could still use art resin but you may have to pour it in layers to avoid overheating
I lubricated the insert with Vaseline but the video footage was not suitable for a family friendly video :/
If you see a Crewmate with graph paper...
He's probably plotting something :/
Over-fill the mould to allow for shrinkage
Once fully cured you can remove the resin pieces from the moulds
Remove any Vaseline residue with a damp cloth
If you play Among Us, let me know your favourite character colour and hat style in the comments :D
The base of the head and the bottom of the feet are sanded smooth
The hats were 3D printed, painted with acrylic and glazed with UV resin
[Alexa] It definitely wasn't me
[Alexa] It was Orange
[Alexa] I saw him escape through the vent
(Never trust Alexa!)