and pull the starter this is an easy pull start so you don't have to pull aggressive just pull gently
hi guys welcome back to Mini Bikes Store video blog in today's
video I'm going to show you step by step how to properly start for the first time
the 49cc Hobbit Sport from Nitro Motors in the previous video I did show
you how to properly assemble the bike and prepare the bike for the first start
and today I will show you all the steps you have to follow to start the bike for
the first time, the Hobbit Sport comes with two-stroke engine so we need to prepare
fuel we have to mix the unleaded fuel with two-stroke oil in the ratio 25:1
with the bike you will receive the mixing bottle I show you now how to use
the mixing bottle and prepare the fuel first you have to prepare the fuel you
have to mix the two-stroke oil for motorbikes with unleaded petrol with the
bike you will receive the mixing bottle when you look close to the mixing bottle
on one side it will say 1:40 and the other side it will say 1:25 so you
have to use the side with the signs for mixing 1:25 so when you look close
you have two lines the bottom line and the top line you have to fill the petrol
up to the bottom line and then fill the oil up to the top line
so I have the bottle filled with petrol up to the bottom line and now just add
oil up to the top line
next close the bottle and shake it well
so now the fuel is ready you can put that fuel into the tank so when you have
the fuel ready put the fuel into the tank
put aprox half of the bottle into the tank
next open the petrol tap
the bike from the box will come with the petrol tap open but here we have the petrol tap
closed so this is an open position like this up and down position its open
position next to the petrol tap you have the choke lever you have to pull the
choke lever all the way up like this and leave it up next put the key into the
ignition and turn it to right on the right-hand side on the handlebars we
have the kill switch you have to put the kill switch on like this make sure
the key switch seats well in position here is off switch so make sure it is
off switch is not stock inside press it a few times here it's working properly
so we have now prepared the bike for the first start we have added properly mix
fuel into the tank we have the ignition ON we have the kill switch in position
we have the petrol tap open and the choke in the up position and now we can
start the bike to start the bike put your right knee on the seat to hold the
bike your left hand on the throttle grip you may need to accelerate a little bit
when you starting and pull the starter this is a easy pull start so you don't
have to pull aggressive just pull gently
till the bike starts like this when the bike starts now push the choke into the
down position now put the choke lever into the down position like this and
leave it in down position when you use the bike when you have the choke in that
down position you can start the bike again
as you can see the engine idle speed is very high in this bike so we need to
lower the engine idle speed on the left hand side on the carburetor you
will see screw with the spring on it that's where you lower the engine idle
speed so to lower it you have to turn that screw into the left
when you lower the engine idle speed you can start the bike again
I have lowered too much the engine is not staying running so if that happen to you
you have to turn that screw into the right a little bit
so I have now regulated the engine
that's how we regulate the engine idle speed you have to make sure that the
idle speed of the engine is as slow as possible otherwise it might damage the
clutch so thank you guys for watching this quick video if you like the bike
you can purchase it from our website the link to our shop is in the description
we send our bikes to 32 European countries
so see you in the next video