1. Unscrew the brake fluid reservoir cap.
Required tools: Wire brush Brake cleaner Copper grease
HEX bit No.H7. Torx bit T30 Wheel impact socket #17 Brake caliper wind back tool
Ratchet wrench Torque wrench Crow bar Wheel chock
2. Raise the front of the car and secure on supports.
3. Unscrew the wheel bolts. Use wheel impact socket #17.
AUTODOC recommends: To avoid injury, hold up the wheel when unscrewing the bolts.
4. Spread the brake pads. Use a crowbar.
5. Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
6. Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
7. Remove the brake caliper.
8. Remove the brake pads. Use a crowbar.
AUTODOC recommends: Tie the caliper to the suspension or to the body with a wire without disconnecting
from the brake hose to prevent depressurization of the brake system. Make sure that the brake caliper is not hanging on the brake hose.
Don't press the brake pedal after the brake caliper has been removed.
As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
9. Unscrew the brake disc fastening Use Torx T30.
10. Remove the brake disc.
11. Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease.
12. Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
13. Install the brake disc.
14. Tighten the brake disc fastening. Use Torx T30. Use a torque wrench. Tighten it to 4 Nm torque.
15. Treat the brake caliper piston. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
16. Press in the brake caliper piston. Use brake caliper wind back tool.
17. Install the brake pads.
18. Install the brake caliper and fix it. Use HEX No.H7. Use a torque wrench. Tighten it to 30 Nm torque.
19. Install the dust boot caps of the brake caliper guide pins.
20. Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
21. Clean the brake disk surface. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
22. Screw in the wheel bolts. Use wheel impact socket #17.
AUTODOC recommends: To avoid injury, hold up the wheel when screwing in the fastening bolts.
23. Lower the car and working in a cross order, tighten the wheel bolts.
Use a torque wrench. Tighten it to 120 Nm torque.
AUTODOC recommends: Check the brake fluid level in the expansion tank and refill if necessary.
24. Tighten the brake fluid reservoir cap.
AUTODOC recommends: Without starting the engine, press the brake pedal several times until you feel significant resistance.