THIS VIDEO HAS NO AUDIO
[Installing the HP JetDirect 2800 NFC & Wireless Direct Accessory]
and set the accessory to the side.
[Find more videos like this]
[at: hp.com/Supportvideos youtube.com/HPPrinterSupport]
Note above the materials needed.
Have a small screwdriver handy.
[Step 1: Remove the HIP cover from the printer]
Power down the device.
Note area in red.
Place small screwdriver tip into bottom HIP cover.
Wait for lights to finish flashing
both at the top and bottom,
then on both sides.
When lights are off, remove the HIP cover.
Set to the side.
[Step 2: Install the HP JetDirect 2800w]
Note areas in red above.
Note cable in opening at bottom of the HIP well.
Pull cable through.
Note female mini USB cable highlighted in red above.
Note male micro USB cable highlighted in red above.
Select male micro USB cable.
As indicated in red above,
plug the connecting cable into its corresponding housing
within the HP JetDirect wireless direct accessory.
Use your fingertip to secure in place.
Note remaining wire component and corresponding tab.
Fit wire end onto tab as indicated above,
again using your fingertip to secure in place.
You are now ready to install
the HP JetDirect wireless direct accessory.
Plug in the male micro USB cable
to the connector point in the base of the HIP well
and set the accessory to the side.
Pulling up the male USB cable attached to the machine,
secure it to the end of the female micro USB cable.
[Step 3: Insert the accessory into the HIP]
Having connected all cables to the HP JetDirect accessory,
you may now insert it into the main machine.
Note tabs indicated in red.
Note corresponding insert areas for the tabs in red.
Assuring the tabs are adjoined securely first,
then making sure all cables are out of the way,
secure the rest of the HP JetDirect accessory in place.
[Step 4: Verify the installation was successful]
Power device on.
Note indicator light is on.
Select square icon second from the right
as indicated in red above.
Note your model number and network connection type
as indicated in red above.
Make sure paper tray is full and close into machine.
From home screen, scroll to the bottom
and select "Administration"
then "Reports,"
then "Configuration Status Pages."
Click the box next to "Configuration Page"
and click "Print."
Await process completion.
Pages will print.
On the Wireless page, check that the model number
and network connection type are correct for your machine.
[For more information about the HP JetDirect 2800 NFC]
[& Wireless Direct Accessory:]
[Find more videos like this]
[at hp.com/supportvideos youtube.com/HPPrinterSupport]