In many of today's high speed serial bus standards
the accurate measurement of single-ended and common mode components of a differential signal
is often compromised by having to rely on multiple probe channels and a scope's internal math capabilities.
Keysight's new InfiniiMax high performance differential probing system
now helps eliminate measurement errors by greatly expanding the capabilities of a differential probe,
making the measurement of different components easier and more accurate.
Keysight's InfiniiMax III+ probes take probing accuracy to the next level with InfiniiMode operation.
InfiniiMode affords more reliable measurements of differential, single-ended,
and common modes through a single probe connection.
For example, measuring the common mode component
of this USB differential signal transmission would normally require two probes and use of the scopes internal math.
With Keysight's InfiniiMax III+ probe just a single probe connection is required.
Plus, easy selection on the probe menu is all it takes to switch
between various measurement modes with no need to reconnect the probe.
Each individual InfiniiMax III probe amp contains the unique S-parameter of each probe and is used with the S-parameter
of the various probe heads to further flatten the probe's frequency response.
This results in more accurate probe connections for more accurate measurements.
For high speed signal probing, solder-in probe heads are commonly used.
Unfortunately solder-in probes
aren't the ideal solution when it comes to moving around multiple test points on a target board.
Keysight's new N2848A, 49A, 51A quick-tip probe provides the industry's
only quick connect, disconnect capability when measuring multiple high speed test points.
Quick-tip probe heads quickly snap into place using magnetic connections to the two sides
of a differential signal and ground.
Install multiple quick-tip probe tips on any device
for quick and reliable measurements of many different probe points.
Keysight's InfiniiMax III+ probes work with the full array of InfiniMax III probe heads
to meet your various connectivity requirements.
For differential measurements Keysight's N5439A ZIF probe head and tips
provide the industry's lowest signal loading for high speed probing.
Keysight's N5445A browser provides superb ease of use with a thumb wheel span control
and Z-axis compliance.
Keysight's N2836A solder-in probe heads provide the full bandwidth for
all InfiniModes with low signal loading.
For cabled measurements, Keysight's N5444A SMA probe
head provides full bandwidth measurement of all modes plus the ability to terminate to a voltage.
It also supports InfiniMode.
Do you need an InfiniiMax probing solution for higher bandwidth signals?
Keysight's InfiniiMax probes come in bandwidths from 1.5 gigahertz up to 30 gigahertz.
Only Keysight InfiniiMax III+ probes combine to deliver the most accurate
measurement of high speed signals with the industry's most flexible connectivity solutions.
Check out the Keysight Infiniium oscilloscope probes and accessories data sheet to find
the right probing solution for your specific needs.
Keysight's new InfiniiMax probing system
in combination with Keysight Infiniium oscilloscopes deliver the performance, accuracy, and ease
of use required for today's best signal integrity.
For more information about Keysight's new
InfiniiMax III+ Probes and other InfiniMax probing solutions visit us at www.keysight.com/find/infiniimax.