g'day i'm nathan from the miners in authorized service center and today i'm going to show you
how to replace a speaker on the gold monster 1000 so firstly you'll need the control box off
your detector you'll need a torx screwdriver and a replacement speaker so firstly you'll want to take
off the six screws that are on the control box so just do it as so there's a two on the front handle
two there and then you've got four on the back of the control box
get all the screws aside without them all falling on the desk
you can take the front control box cover off there like that and you'll find there's
another four screws on the can on the circuit board there to pull off as well fortunately all
the screws the exact same so you don't have to worry about misplacing them in the wrong spot
now that we've pulled those screws out before we take the circuit board off
the uh the rest of the control box you want to un take off this little membrane
this little cable here so you'll need to push this back a little flap there
and then you'll want to pull it out just be very gentle because they they can be damaged
that's the speaker cable so now that that's off like so now we can take the circuit board off
that's the entire circuit board just leaving it hanging there it's just fine
so what we'll do is we'll take these nice last two screws out
and that will release the speaker from the rest of the control box
like so now we can pull this whole cover out and now we've got the whole cover out with the speaker
now the speaker is quite easy you can just sort of pull it out like so just be mindful of it again
so there's the old one get rid of the old one and we'll get the new one we'll feed the new
one in like so feed it around a little bit it's in a good spot same as your the other speaker
we'll then feed it through like so perhaps a little bit more
and then feed that through a little slot like that
so now it's in the original spot as the old speaker was and then what we do we put it back in
to the control box and put these two bottom screws in
like so as i said before all the screws are the same so it doesn't matter which screw goes where
there we go just push them down a little bit out of the way
and what we'll do is put the circuit board back around
get that right here and put some screws into it so start off with the two bottom ones
now i've screwed the circuit board back on now i'm just going to put put this little membrane
cable that goes from the speaker back onto the circuit board we just need to be quite careful
with it and slide it back into its original slot which can be quite difficult sometimes
but there we go we've succeeded it's in there so we just need to push the little plastic tab back
and now that speaker cable's in now we can put the cover back on slides on like so first two screws
and four back ones
and there we are we have replaced the speaker on a gold monster 1000 and i'm nathan from
miners den authorised service center and this was a tech tip for the mind lab show