Take out the main machine and all the accessories Accessories:
White Rubber Hose x1 Black Rubber Hose x1
Red Rubber Hose x1 Diamond Wands x3
Spray Gun x1 pc Diamond Tips x9
Black Rubber Rings x6 Glass Tubes x3
Cotton Filter x1 pack Power Cord x1
Put the 3 diamond wands on the handle holder of the main machine in order
Put the 9 diamond tips on the machine in order When you face the machine, the Outlet is on
the left and the Inlet is on the right When using Microdermabrasion, take out the
white rubber hose, insert one end into the Inlet and the other end into the tail of the
diamond wand Take out 6 black rubber rings, install them
to the wands. You can substitute the ring when it is broken
Note: The black rubber ring is a must. Otherwise there is very low suction or no suction.
Choose a diamond tip Note: The cotton filter is a must.
Then twist the tip on to the wand
Connect the device with the power supply Press the power button to start the machine
Rotate the knob to adjust suction . Rotate it to the left to decrease the suction and
rotate it to the right to increase the suction. The stronger suction level is, the tighter
the tip sucks onto your skin. The process is advised to be around 10 min.
Turn off the machine to stop. Take off the diamond tip after the operation,
take out the cotton filter and throw it away Clean the diamond tip with clean water to
use for later Take out the 3 glass tubes
flat tube is for forehead and cheek; long tube is for nose and nasolabial folds;
bent tube is for chin, nose and cheek Choose based on your need
Pull off the white rubber hose from the wand and install the glass tube to the white rubber
hose
Rotate the knob to adjust suction. There is a small round hole on the glass tube,
press the round hole with your forefinger when operating, release your forefinger to
stop. Press the power button to turn off the device.
Clean the glass tube with clean water to use for later
Take out the red rubber hose and Spray Gun. Insert one end of the red rubber hose into
the outlet of the machine, and insert the other end into the connector under the Spray
Gun. Attention: Do not insert the red rubber hose
into the Inlet! There is a water box on the Spray Gun. Fill
clean water or toner/watery essence/other watery products in the water box. Choose based
based on your skin type Turn on the device first.
Press on the Start button on the Spray Gun with your thumb to spray. It can be used for
moisturizing, cleansing, infusing nutrition to the skin and softening skin.
Release your thumb to stop. Turn off the machine.
Dump the remaining water in the water box, clean the spray gun and store it away.