hey guys welcome back to Mini Bike Store Video Blog
today I'm going to show you how to
properly start the 49cc Gepard Tuning mini dirt bike from Nitro Motors
you can purchase this bike on our website the link to our shops in the description
first you have to prepare the fuel
you have to mix the two-stroke oil for motorbikes with unleaded petrol
with the bike you will receive the mixing bottle
when you look close to the mixing bottle
on one side it will say 1:40 and the other side it will say 1:25
so you have to use the side with the signs for mixing 1:25
so when you look close you have two lines
the bottom line and the top line
you have to fill the petrol up to the bottom line
and then fill the oil up to the top line
so I have the bottle fill it with petrol
up to the bottom line and now just add oil
up to the top line
next close the bottle and shake it well
so now the fuel is ready you can put that fuel into the tank
next put the fuel into the tank
next turn the ignition into ON position, right
place the kill switch in position
and you can check the on/off switch make sure it's not stuck inside
here it's working properly
open the petrol top it's located just here so
so turn it to ON
next move the choke lever into down position
it will lock in down position
so we have added the properly mixed fuel into the tank we have checked the switches
the ignition switch the kill switch
the on/off switch
we have the petrol tab open
and we have the choke in the up position
so now we can start the bike
to start the engine place your right knee on the seat to hold the bike
your left hand on the throttle grip
and pull the starter
when you're starting you may need to twist
the throttle a little bit
when the bike starts you have to pull the choke forward
the choke lever will come back to up position
and you have to leave it in this position when you use the bike
now you can start the bike again
again place your right knee on the seat
your left hand on the throttle
and start the bike again
if the engine revs are too high
you will need to adjust the idle speed of the engine
on the right hand side on the carburetor
here you will see little screw with the spring on it
that's where you adjust the engine idle speed
so when you turn this screw in to the right
it will higher the idle speed
if you turn the screw in to the left it will lower the engine idle speed
it's very important, you have to always keep the engine idle speed
as low as possible
thank you guys for watching this short video
if you liked the bike you can purchase it from our website
link to our shop is in the description
please don't forget to subscribe, and see you in the next video