hi I'm Brian at monster transmissions we have your valve body here your shift
plate and per instructions of the kit drill 5/64 hole right here right there a
1/8 hole
right there
at 3/32 right here that's your shift plate
on your valve body we're going to replace the solenoid pressure valve with a steel nonstick valve
make sure it's nice and free
and your spring and retainer back in
okay and your pressure regulator valve here move the end plug check the valve
inside of there make sure that's nice and free remove the spring
replace it with the longer blue spring supplied in a shift kit and then
reinstall the end plug
that'll boost your pressure make a shift firmer on your you 1 2 & 2 3 shift by
the end plug tends to leak so we replace it with a new one with an o-ring on it
which helps it feel better
install your retaining clip check to make sure all your valves are nice and free
then you can reassemble the valve body install all eight check balls
then you can reassemble your valve body
there with a gasket and backing plate
you have two bolts with dolphins on the end of it to help line everything up we
have a bunch of sharp hooks
snug these down just torque them 60 inch pounds
flip it over
install your check balls just eight check balls in here
your gasket
should line right up over those those pins you installed
your shift plate
these cover plates are line up to the specific way or the veins on here so
fluid can pass through
one bolt there rush pin here , torque them
done with your valve body and on your accumulators, replace the factory springs
these two red ones going the bottom here
accumulator
green on top all right your accumulator cover on top some assembly Lube on it
snap ring ready
just like so you add this to this accumulator down here
strengthen the spring tension
with your cover now we're ready to put the body back on
your EPC hold down bracket
your lockup solenoid
and your shift solenoids
short bolt goes through the lockup solenoid there
it's a solid one-piece electrical connector instead of wires it goes to
all your solenoid here snap it down
filter
just installed a level-two shift kit for a 4R75 if you have any questions
give us a call at monster transmission we'd be glad to assist you