Hi, my name is Sarath Jaladi and I'm here with the BRECOflex applications
engineering department. Today I'll be talking to you guys about our ATN
convertible timing belt system. With this timing belt system you can use our
connecting kits to easily assemble and disassemble your timing belt while it's
on the machine, with just a couple of screws. Additionally using our ATN
inserts, which come in brass, nylon and stainless steel, you can easily screw
down profiles up to 100 millimeter wide on your belt. Additionally while your
belt is on the machine you can remove and move around the profiles to adjust
the spacing between them. This allows you to quickly iterate between different
profile configurations without ever having to remove your belt from the
machine. In the next part of the video I will show you how to assemble the ATN
connecting kit as well as the profiles on and off the belt.
To assemble your ATN belt with the connecting kit, first slide the fingers together
to ensure that they are aligned properly.
Then take the black nylon inserts and press them firmly into the allotted
spaces in the to side of the belt once you have inserted all of the nylon
inserts you can go ahead and flip the belt over and prepare for the other part
of the installation process. Now take one flat metal plate and two of
the small screws provided and using a small Phillips head screwdriver drive
the screws into the belt. In this example we are partially driving the screws into
the belt using a small hand screwdriver and then we will finish the installation
process using an electric screwdriver.
It is important to note that one side of the plates have chamfered holes for the screw heads to sit flush with the
surface of the plate it is key to keep this side of the plate facing upward so the
screw heads do not protrude and cause any snags.
As you can see here once we finish hand tightening all of the plates we will
then use the electric screwdriver to finish the installation process.
It is important to tighten the plates down completely until they are pressed firmly
against the back of the belt. This will ensure that the plates do not come loose
or ride up while going around the pulleys. Once again an electric
screwdriver is not required for this process but does make it faster and easier.
Now that we have assembled are connecting tip you can see here we've
put the belt around some pulleys now we will demonstrate how the ATN insert
system works to attach profiles to the belt back. As you can see here we insert
the brass stainless or nylon nuts into the tooth side of the belt and then
place the inserts down and screw them down. You can also easily remove the
inserts and profiles that has been already put on the belt while your belt
is on the machine and move them around to adjust your profile spacing.
You can also remove a plate from the connecting kit and replace it with insert nuts and
an insert as you can see here.
For more information about our ATN convertible timing belt system download
our catalog at the link below. For technical questions and information on
how to order this belt call the number at the end of this video. Thanks for watching.