Required tools: Wire brush WD-40 spray Copper grease
Torx bit T30 Drive socket # 12 Wheel impact socket #17 Ratchet wrench
Torque wrench Tap wrench Impact screwdriver
Hub slide hammer puller Wheel chock
1. Raise the rear of the car and secure on supports.
2. Unscrew the wheel bolts. Use wheel impact socket #17.
AUTODOC recommends: To avoid injury, hold up the wheel when unscrewing the bolts.
3. Clean the brake drum. Use a wire brush. Use WD-40 spray.
4. Unscrew the brake drum fastening. Use Torx T30. Use an impact screwdriver.
5. Remove the brake drum.
AUTODOC recommends: Examine the brake drum. Replace it if necessary.
6. Clean the ABS sensor fastener. Use a wire brush. Use WD-40 spray.
7. Unscrew the ABS sensor fastener. Use Torx T30. Use a ratchet wrench.
8. Disconnect the ABS sensor.
9. Clean the wheel hub fastener. Use a wire brush. Use WD-40 spray.
10. Unscrew the hub bearing mounting. Use a drive socket #12. Use a ratchet wrench.
Use a tap wrench.
11. Remove the hub and the bearing together, since they are a sealed unit. Use the hub slide hammer puller.
12. Clean the hub bearing mounting seat. Use a wire brush.
13. Install the new wheel hub with a bearing.
14. Tighten the fastener of the wheel hub bearing. Use a drive socket #12.
Use a torque wrench. Tighten it to 65 nm torque.
AUTODOC recommends: The wheel bearing unit must not tilt on the axle pin.
15. Connect the ABS sensor.
16. Screw in the ABS sensor fastener. Use Torx T30. Use a ratchet wrench.
17. Treat the wheel hub in the area where it contacts the brake drum. Use copper grease.
18. Install the brake drum and fasten it.
19. Tighten the brake drum fastener. Use Torx T30. Use a torque wrench.
Tighten it to 9 Nm torque.
20. Clean the wheel rim mounting seat. Use a wire brush.
21. Treat the surface where the wheel rim contacts the brake drum. Use copper grease.
22. Treat the fasteners of the wheel hub bearing. Use copper grease.
23. Screw in the wheel bolts. Use wheel impact socket #17.
AUTODOC recommends: To avoid injury, hold up the wheel when screwing in the fastening bolts.
24. Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench.
Tighten it to 120 nm torque.