Hi guys.
John here with realtruck.com.
Today I want to show you how to install the Bushwacker Extend-a-Fender Flares onto this
2014 GMC Sierra Denali.
[Music]
All right guys, as you can see here, this kit comes with everything you need to get
these installed onto your truck.
You have the front and rear fender flares for both sides and you also have the seal
trim that goes around the fender flares to help protect your body paint and also to keep
water and other stuff from getting in behind these and causing some problems.
So, also comes with your instructions and your limited lifetime warranty explanation
card.
So, the next step of this process is to get these things on this truck.
Okay guys, the first thing we want to do is take our seal and as you can see, there's
some red plastic coating on the back of it.
You want to peel that off but we don't want to peel it off of the whole strip.
We only want to peel back a little bit at a time and then we'll start putting this onto
the flare itself.
Okay guys, we've got our seal onto our new fender flare.
So, the next thing we want to do is remove these old factory ones because we're going
to have to use the bolt holes and such up underneath the fender here to attach that
new one.
So, we're going to take this one off and get our new one on here.
We've got our factory flare off and the next thing we need to do before we can actually
go with a test fit of this is we need to pull the screws out of this inner fender liner
because, if you can see right here on the back of this fender flare, you see this piece
inside here and you've got the space in here?
Well, what we need to do with this is this piece, your fender liner needs to slide in
between here, and that will allow this fender flare to fit back on there better.
So, what you're going to do, and I've already went ahead and taken the screws out of the
inner fender liner here just so I can show you, what you want to do is just pull the
inner fender liner down and you can bring this down here where you can get to it and
slide this section right here in between there when you put this up on there.
So, we've got that inner liner slid in there where it's supposed to be and look here and
see that, looks like our fender flare fits really nicely.
So, we're going to go ahead at this point and mark our holes where we're going to have
to drill a couple of holes in here into the fender area so that we can actually attach
this on because there's two, you have four holes that are factory drilled holes that
will work for you and those are the two that are up under here that we took out of our
old one and then the two down here on the bottom side on the bottom edge that we took
out of our old one.
Now, this one here, and the one up here in the front, we'll have to mark and drill.
We've got our hole drilled for our screw to go into the body so what we want to do now
is to put our flare back on here.
Get our inner fender liner all backed up inside that slot where it goes in the fender flare.
There we go.
[Music]
Okay guys, we've got all of our fender flares attached to our truck.
So, there you have it.
That's how easy it is to install the Bushwacker Extend-a-Fender Flare onto your GMC Sierra.
So, let's take a look at this truck and until next time, remember, happy motoring.
[Music]