Hello, this video will demonstrate how to setup IO Scanning with a 340 PLC via the NOE100 Module
to send and receive data to a remote device
in this example our remote device will be an M580
So I will read from the %MW1500, %MW1501 from the M580
and then I will write to %MW1503, %MW1504 from the NOE
of the Italy
All right, let's begin!
So I will add an NOE100 Module
Create a network
I will call it NOE100 and click ok
Ok so it's already there
so sorry M
And I will link it
There is my NOE
So now that it has been linked
I will go in to the network and give it an IP Address
So that's the IP Address of my NOE
Then I will go here to enable and say YES to IO Scanning
Go to IO Scanning I will enter your remote device information here
in my case, to IP address of my M80
My IP address for the M580 is
192.168.140.30
Leave pretty much everything here, Unit ID default, 1500 milliseconds for the timeout and 60 milliseconds for the rep rate
so
The data will come in to %MW0 and I will read it from %MW1500 and %MW1501
So I'll start at 1500
for a length of 2
And then I'm going to write the data to
the data in %MW10
To %MW1503 and %MW1504 in the M580
for a length of 2
All right that's it
All right let's confirm the change
I will build the project
I will connect to the PLC and download
So as you can see I'm reading the value
I am reading of values
from my M580
So I can change this here to
And as you can see over here the values updated
so here is where I will write to the 580
and I'll just put some values here
and let's just go to 1503
and 1504 respectively
There we have it, so we know the communication is working
and
that's, that's it
Thanks for watching!