Hey how's it going?
Mike from 1A Auto.
I'm gonna show you how to remove and reinstall inside door handle.
This is a 2001 Lexus GS 300.
It should be the same for '98 to 2005.
I'm showing you on the driver's side, the passenger's side front is the same as well.
First you'll need a hooked pick tool and just go in behind.
I'm gonna pull this panel off.
And now there are eight Phillips screws to remove.
One right behind that panel, one inside here, there's one right below your door pull here,
one with a bumper on it there and then four right up underneath.
Phillips screwdriver to remove those.
And for a bunch of these, you could use an 8 millimeter socket and ratchet.
All right.
Now there's a few clips in the front and the back.
So you usually just use your fingers.
You might want to use a flat blade screwdriver.
Just pull firmly and they release.
And then once you've released all those, and it's kind of loose, you want to almost twist
the top so that this will go by here.
Pull out, but also pull on this so the top comes up and then rotate it up, slide it back,
pull the top out and off.
And then in behind, there are the two cables for your door handle.
Pull them out and then pull that up and out like that.
Same thing here--pull out and this one goes down and comes out and then two electrical
connections.
Push on the tab, disconnect and then down here, the tab is right at the bottom, push
on the tab and disconnect.
Oops--one more and then way down at the bottom, again little tab, push and disconnect.
Okay with the door panel out, put it on it's face, and there are just two Phillips screws
that hold the door panel.
This one's really easy to get to.
This one, you're going to use a regular screwdriver.
Angle it up in there and get it out well enough.
And then just push on your door handle from the other side and pull it right out.
To install the new door handle, kinda angle it up and push it in.
Lift up the panel, and lock it into place.
Reinstall your two screws.
Reinstall the door panel.
There's three electrical connectors, the courtesy light way down at the bottom.
Our master power window switch right in the middle, and then our power door lock switch
up here at the top and then these go in.
This first one goes from the bottom, and then up and around.
This one goes in from the top.
Then pushes in, and then tilt the back of the panel up.
Push the front end first and then as you go forward, bring the panel down and on and lock
those clips into place.
The larger screw that has no bolt head goes in behind here and then the rest of them are
the Phillips screw and 8 millimeter bolts.
I always like to start 'em all fresh before I take them up.
I just make sure that they're all lined up.
And then when you tighten them, you don't have to tighten 'em, just get 'em snug so
you know they're holding.
You don't want to strip the plastic clips they go into.
This plastic cover, put it in place.
Kinda push the front in first and snap it in.
Thanks for watching.
Visit 1AAuto.com, your place for DIY auto repairs, for great parts, great service and
more content.