well welcome back to the Steve Robb show today part 2 voltage drop testing on the Bosch table
saw and guys I don't know what to expect I got everything all set up the same as before got the
generator sitting over here beside the heater and we're going to try this now I did take the
generator and I left it outside the garage and I had it running for a bit because the last thing
you want to do is start this thing up inside here after it's been stored away because it'll
just smoke you right out so let's get started I'll show you the setup that I got going on and
for use that are just new to the channel what I'm doing is I'd like to have a baseline of exactly
can my generator run this so I'm gonna look at the specifications on the fleu 289 when we do
the test and let's see if this can be run by my Furman generator and run correctly I really
don't know but I know there's a lot of people on my channel that do know what the lost you could
possibly expect to run a piece of equipment right without doing long-term damage to it so I'll show
you the setup let's get to it ok so there we are for you that are been on the channel for a long
time you can recognize my Dewalt heater and you can recognize my firm and genset that i've been
using and it's worked out great so far so i got the exact same cord as the other testing so you
got to be consistent and we got everything running up here to my splitter and into the meter and all
I'm going to do is turn the machine on we'll take a look at the readings and I'd really appreciate
it if you guys could let me know if this is all kosher or not because to me I'm not too
sure I believe the last time we tested this on my regular household current on my electricity
it went down to a low I believe of a hundred and ten volts and then of course it went up in
a [ __ ] perfectly so let's take a look at the testing here what I'll do is I'll just open the
garage a bit so I don't smoke myself out with the fumes and let's get testing okay you should
be able to hear me start off the genset now and make it a little bit loud here and that will do it
well there we are 101 three I'll reset it
okay it went down pretty low they're like 95 and then it came right up it averaged great
and it seemed to run just fine now do you think 95 is too low I've often heard that electrical
appliances have a I guess a little bit of a leeway there of plus or minus 10% so 95
is that good is that bad I don't know it seemed to run it fine and what do you guys think so if
you won't mind you know leave a comment down below and let me know what you think I mean
I'm going to run it like this it seems to be fine seems to work fine like this so it didn't seem to
struggle or be under labor or anything like that so thanks for joining in I hope you enjoyed this
little bit of an experiment and you's guys never seen this channel before you're always welcome to
subscribe come back again guys let's have some more fun oh by the way there's a mod on this
and that mod is coming up you've probably never seen it before on youtube you'll never see it
again on youtube again it's going to be pretty interesting for yous guys that enjoy working
with machinery like this and I've adapted this to another piece of equipment that's gone I'll
blow your mind stay tuned for that cheers guys let's come back let's have some more fun bye