1. Unscrew the brake fluid reservoir cap.
Required tools: Wire brush WD-40 spray Brake cleaner
Copper grease Brake caliper guide pins grease Drive socket # 14 Drive socket # 19
Wheel impact socket #21 Brake caliper wind back tool Ratchet wrench
Torque wrench Tap wrench Crow bar Wheel chock
2. Raise the rear of the car and secure on supports.
3. Unscrew the wheel bolts. Use wheel impact socket #21.
AUTODOC recommends: To avoid injury, hold up the wheel when unscrewing the bolts.
4. Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
5. Spread the brake pads. Use a crowbar.
6. Unscrew the brake caliper fastening. Use a drive socket #14. Use a ratchet wrench.
7. Remove the brake caliper.
AUTODOC recommends: Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.
Make sure that the brake caliper is not hanging on the brake hose.
Don't press the brake pedal after the brake caliper has been removed.
As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
8. Remove the brake pads. Use a crowbar.
9. Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
10. Treat the brake caliper piston. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
11. Press in the brake caliper piston. Use brake caliper wind back tool.
12. Install the brake pads.
13. Clean old grease and rust stains, if there are any, from the caliper guide pins and guide pin boots.
14. Lubricate guide pins with special brake grease.
15. Install the brake caliper and fix it. Use a drive socket #14. Use a torque wrench. Tighten it to 43 Nm torque.
16. Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
17. Unscrew the caliper bracket fastening. Use a drive socket #17. Use a tap wrench.
18. Remove the brake caliper together with its bracket.
AUTODOC recommends: Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.
19. Remove the brake disc.
20. Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease.
21. Install the brake disc.
22. Install the brake caliper together with its bracket.
23. Tighten the brake caliper bracket. Use a drive socket #17.
Use a torque wrench. Tighten it to 84 Nm torque.
24. Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
25. Clean the brake disk surface. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
26. Screw in the wheel bolts. Use wheel impact socket #21.
AUTODOC recommends: To avoid injury, hold up the wheel when screwing in the fastening bolts.
27. Lower the car and working in a cross order, tighten the wheel bolts.
Use a torque wrench. Tighten it to 108 Nm torque.
AUTODOC recommends: Check the brake fluid level in the expansion tank and refill if necessary.
28. Tighten the brake fluid reservoir cap.
AUTODOC recommends: Without starting the engine, press the brake pedal several times until you feel significant resistance.