please subscribe and support this channel you can support by giving a comment or give a like to the video
dd-wrt client mode setup
this setup is not a
wired connection is a wireless connection between two routers only
the router that you are trying to connect to is the primary router
the router you are configuring is the client mode router
a router in client mode connects to another wireless access point
the host router it uses its wireless connection as the one interface
it shares the internet connection only to the land ports
it is not seen as an access point by laptops or other computers
and does not accept wireless connections from client devices
the main and secondary router are on separate subnets
network address translation is use between the routers
and when port forwarding is needed it must be configured at both routers
the router in client mode must use its own DHCP server
to give out IP numbers gateway and DNS server to the devices connected to its
land ports
now with the setup
open a web browser and connect to your router type your username and password
iand to a clean set up go to administration
factory defaults and restore to factory defaults
now wait until he do his thing and thirty to forty seconds later
connect again to the router by as default IP
192.168.1.1
choose a new user name and password
next go to Wireless wireless security
now select the security mode
and other key information that matches your primary router which you will be
connecting
after you configure exactly the wireless
security has the first router click to save
next go to
basic settings
on wireless mode
select client
choose the wireless network
mode
give the same SSID
from the primary router
assign to the same wireless channel
as optional set the correct
ACK aknowledge time
in meters
and save the
changes
next go to set up basic setup
on connection type select DHCP
choose a router name
in the network setup section set a local IP address to the next subnet available
your client subnet must differ from the primary router subnet
for example if the primary router ends on 0.1
choose 1.1
as optional set static DNS servers in the network address server settings
if you're wide area network not provide them or
you want to use a different DNS
next change your time
zone and DST to match where you are
optional set a server IP name
the name for in time sending section for network type protocol
it will use a hidden default server if you leave it blank
and save the changes
as optional if you do not need to
worry about security between the access point and the client router
go to security firewall and disabled the SPI firewall
now save and apply settings
set your computer back to auto IP
and auto DNS if you like you will get a DHCP address from the router
the client router should connect to the access point within a minute or less
you may need to unplug the router for 20 seconds if the router doesn't reset
after you ensure that it does connect you may configure any other settings
for example virtual interface for wireless connection
client mode setup successful now if your first router have access to Internet
you can return to this video and give a comment a thumbs up and subscribe
I hope this video was helpful thanks
please subscribe and support this channel
you can
support by giving a comment or give a like to the video
thanks