Hi I'm Mat from eSpares.
In this video I'll be showing you how to change the heater on the Samsung washing machine.
if your machine cannot complete a wash cycle
and you don't feel any heat from the door glass even on a boil wash.
It's likely that your heater has failed and it needs replacing.
Safety first: Always unplug an appliance before carrying out any work.
The heater on this machine can be accessed by taking off the front panel.
Do make sure that's the same for your machine before beginning the dismantling process.
The next thing I need to do is to remove the top of the appliance by undoing these two screws at the back.
With the top of the appliance off
next remove the detergent drawer and unscrew the control panel
held in by two screws near the detergent drawer and one on the side.
With the control panel unscrewed just loosen that slightly
next I need to remove the outer band retaining band
that holds on the door seal and then just push the door seal inside the front panel
because this whole front panel needs to be taken off.
So just use a flathead screwdriver around the spring parts of the outer retaining band.
and then work it around.
I now need to remove the kick panel at the bottom using a flat head screwdriver
just work it in between the two panels and it should release.
Wwith the kick panel removed I can now undo this front panel
by first undoing these four screws at the bottom.
and then unscrew the three at the top and lift the front panel off.
With the screws out you can just see that the front panel is held on by these two hooks at either end.
so I'm just going to let the control panel drop down
and lift the front panel away from the bottom and then just lifted off those two hooks.
And here we can see the electric connections to the door lock, so just remove those.
And the front panel is now free.
And here we can see the heater and its electrical connections
so I need to remove these electrical connections on your model you may want to take a photograph
but I won't be doing it here because the length of the wires indicate the positions.
So here we have the nut and clamp that holds the heater in place.
So what I am going to do is use a box driver to take the nut to the very end of the shaft
and then give the shaft a quick tap to release the clamp.
With the clamp released these heaters can be very stiff, very hard to get out of the tub.
So it's a good idea to grab yourself a flat headed screwdriver
and just work it between the heater and the tub to release it.
And here we have the heater, as you can see this one is particularly covered in lime scale
and if that's the case for your machine you can see our how to cure a smelly washing machine video
which deals with lime scale on the heaters.
Here we have a new heater, top tip: it's a good idea to grab some washing up liquid
just put it around the seal part of the heater this will help fit it into the tub.
And it's important that you make sure the heater goes in nice and straight to the tub.
if you put it in to high you can hear it hitting the drum there.
So make sure you put it in nice and straight and has a clamp that holds it into position.
You can then tighten the bolt with a box driver.
Reconnect the electrical connectors.
Top Tip: start with the one nearest to you so that none of the wires crossover.
Re screw in the front panel making sure to reconnect the door lock electrical connector first.
Refit the control panel and as we are up the top re screw it in.
Replace the detergent draw then I can screw in the bottom of the front panel
and replace the kick plate.
With the kick plate in place I can now re attach the seal to the front panel,
and re secure it with the sprung band.
Start with the spring first near the hinge, and then work the band from top to bottom around the seal.
And finally replace the top and screw it in.
And there we have it, one new heater fitted to the Samsung washing machine.
Spares and accessories for all appliances can be found on the eSpares website.
Thanks for watching.