Assembling the TD-50K
Assembling the Stand (MDS-50K)
Loosen the hand knobs, extend the legs of the stand, and then re-tighten the hand knobs.
Attach the cymbal mount rods (2 locations).
Change the orientation of the pad mount rods (2 locations).
Change the orientation of the cymbal mount.
Change the orientation of the pad mount, and slide it against the holder.
Change the orientation of the sound module mount, and change the orientation of the sound module mounting plate.
Place the kick pad (example: the KD-120BK).
Fasten the kick pedal to the kick pad (example: the KD-120BK).
Mounting the Pads
Adjust the orientation of the pad mount, and attach the PDX-100 pads (3 locations).
Mounting the Cymbals
Adjust the orientation of the cymbal mount.
Use a drum key to fasten the stopper.
Tighten the felt washer and wing nut so that the CY-18DR has the appropriate amount of sway.
Adjust the orientation of the cymbal mount.
Use a drum key to fasten the stopper.
Tighten the felt washer and wing nut so that the CY-13R has the appropriate amount of sway.
Adjust the orientation of the cymbal mount.
Use a drum key to fasten the stopper.
Tighten the felt washer and wing nut so that the CY-12C has the appropriate amount of sway.
Assembling the Hi-Hat (VH-11)
Prepare the hi-hat stand.
Verify that the cymbal rod is firmly fastened.
With its sponge side upward, place the insulating plate on top of the cymbal receiver (felt or rubber component) of the hi-hat stand.
Pass the motion sensor unit over the cymbal rod.
Position the jack of the motion sensor unit toward the back.
Loosen the clutch screw, and attach the hi-hat.
Lightly press the pedal, and tighten the clutch screw.
Calibration is required the first time you connect the hi-hat to the sound module. For details, refer to the owner's manual.
Place the hi-hat and snare drum.
Connecting the Cables
Remove the cables from the stand.
Do not pull the cables with excessive force. Doing so might break the wires.
Referring to the table, connect a cable to each pad (8 cables).
Remove the CY-18DR's cable from the cable holder.
Connect the included connection cable, and use the protector to lock the connectors together.
Remove the PD-140DS's cable from the cable holder.
Connect the included connection cable, and use the protector to lock the connectors together.
Attaching the Drum Sound Module
Remove the sound module mounting plate.
Use screws to attach the sound module mounting plate to the back side of the sound module (4 locations).
To prevent damage to the sound module's operation panel, perform this step on cushioning material (such as a soft cloth).
Attach the sound module to the sound module mount.
Connecting the Cables to Drum Sound Module
Connect the cables to the sound module's TRIGGER INPUT jacks (10 cables).
Do not pull the cables with excessive force. Doing so might break the wires.
Connect the cables to the DIGITAL TRIGGER IN ports (CY-18DR, PD-140DS).
They can be connected to any of the ports.
Adjust the pads to comfortable playing positions.
Use the included cable clips and cable ties to secure unnecessary lengths of cable.
Do not pull the cables with excessive force. Doing so might break the wires.
Connect the power cord to the sound module's AC IN jack.
This completes setup of the TD-50K.