Hi everyone, Welcome back to geardo,
Today we will show you how to replace the front and back cameras on the Samsung
Galaxy s20 Plus mobile phone. To start, we need to have the
right tools to proceed with the repair, which You can find in the description.
First, Take out the Sim tray and then the back cover removal.
To remove the back cover, it needs to heat gently around
the back cover edges until the pasted adhesive becomes soft.
For this, we are using a heating pad. Place the back cover side on
the heating pad and Select the mobile phone HEATING option and leave it till
it completes. Alternatively, you can use a heat gun or hairdryer.
Once the heating has completed,
Use a suction cup to create an opening between the frame and rear cover.
Next, insert a plastic card pry tool or something similar to cut the adhesive around the back cover.
Next,
take out the back cover and disconnect the connector to take out the wireless pad.
ANd also disconnect the battery plug.
Next, take out the logic board frame by undoing six screws.
Next, disconnect and take out the front camera from the logic board. If you have a
broken front camera, replace the front camera with a new unit and start closing the device.
Next, take out the logic board, first, loosen four connector plugs attached to the logic board.
And then undo two screws and gently lift the board using a pry tool or tweezer.
Next, disconnect and pull out the telephoto camera.
Next, disconnect and pull out the two in one wide
camera and depth camera plugs from the rear side of the logic board.
Next, place the new depth and two in one wide camera modules on the board.
Next, place and secure the new telephoto camera.
Next, place and secure the logic board on the body.
Next, place the front camera in the board.
Next, fasten four connector plugs into the board.
Next, secure the board by adding two screws.
Next, Secure the logic board frame by adding six screws,
Next, add the sim tray, and place and secure the wireless pad.
Next, connect the battery plug.
Next, Before installing the main back cover, make sure it has enough glue.
If not, use B7000 glue or a new double-sided back cover adhesive.
Finally, we are using binding clips to tighten the back cover to the body.
If not, you can use rubber bands and leave them for some time.
I hope you have enjoyed the camera replacement guide.
Let us know if you have any questions; please share and comment on our videos.
DO not forget to hit the subscribe button.