Hi everyone, Welcome back to geardo,
Today we will show you how to replace the camera lens glass & back cover on the Oneplus
Nord N200 mobile phone.
To start, we need to have the right tools to proceed with the repair, which You can
find in the description.
First, turn off the phone and follows with the back cover removal.
For removing the back cover, it needs to heat gently around the rear cover edges until the
pasted adhesive becomes soft.
For this, we are using a heating pad.
Place the back cover side on the heating pad and Select the mobile phone HEATING option
and leave it till it completes.
Alternatively, you can use a heat gun or hairdryer.
Once the heating has completed, Use a suction cup to create an opening between the frame
and rear cover.
Next, insert a plastic card pry tool or something similar to cut the adhesive around the back
cover.
Take out the back cover, and Next, Take out the midframe by undoing seventeen screws from
the top and bottom.
And then, Using a plastic card pry tool, create an opening to separate the back cover frame.
Be gentle and workaround on the edges to disengage the plastic clips.
Make sure the sim tray is out.
Next, disconnect the battery plug and then disconnect the fingerprint plug to release
the midframe from the body.
Next, Apply heat to the camera lens glasses.
For this, we are using a heat gun.
And then slightly apply pressure from the rear side to take out the required lens.
If you are replacing only rings, You can follow the same steps for other rings too.
Next, Place the new camera lens glass ring or rings with adhesive.
Next, if needed, can take out the lens with the frame.
First, apply heat on the lens area from the front side.
Next, slightly apply pressure from the rear side to take out the lens with the frame.
Next, secure the new camera lens frame in the mid frame by applying adhesive.
Try to clean the adhesive surface as much as possible.
Next, secure the fingerprint and battery plugs to the board.
Next, place and secure the midframe by adding seventeen screws.
Ensure the clips have fastened before inserting screws, and also insert the sim tray.
Next, Before installing the main back cover, make sure it has enough glue; if not, use
B7000 glue or a new double-sided back cover adhesive.
Finally, we are adding binding clips to tighten the rear cover with the body.
If not, you can use some rubber bands and Leave them for some time.
I hope you have enjoyed the replacement guide.
Let us know if you have any questions; please like, share, and comment on our videos.
DO not forget to hit the subscribe button.