Hello everybody today we're gonna be starting our custom micro drone build
this going to be the best drone on a budget we're going to use in the Eachine Tiny F3 Evo Micro Flight Controller
evolution fly bolt from evolution this is the tiny micro board weighs 2
grams costly 12 dollar when using the 3 in one a PV system the TX o 2 with a
upgrade antenna I'm going to be using the Eachine 45c battery costed only three dollar
and the camera costed 18dollar and the furibee F36 motors are given me
40 grams of trust and this cost me five bucks
and this is the Furibee F36 frame that cost me one and a half bucks so altogether I
was $40 all in we are also going to be using this flysky FS A8S receiver
the weighs only one half gram we have a range modification for it
that video will show up over hire this is perfect for that little
micro builds and with this way I can be using a flysky radio but i
use the turnigy evolution radio that's why I'm using this micro receiver
first thing we going to be doing a modification to my really good nice
frame so I really like this furibee frame I'm going to move this back pin because
it's sitting in the way on the flight controller so I went ahead and skip in the built
and put all the wires tru the frame now it's just a
question of this fly board soldering all wires to it
I'm using s bus on the receiver and this white wire is the signal wire that we have to ew-solder
to the uart2 to the receiver end its a little bit tricky to show this up on
camera now it's just a question of soldering postive five volts in and ground
to the receiver we have most of all wires soldered to our flight board now it's
just a question of putting it in frame soldering the motor wires and make sure
that they are spinning the correct way iff they they don't than just change out the motor wires and
we have fixed and we finished off to build a little bit more we finish the
notches into the frame so the camera can sit in there and also directly into the
thrust keeping the camera a really cool that is really good because it turn on
really hot and then you lose video connection no you don't want that I can
see this is a flight board be sitting inside the frame at the same height as the
moters with the receiver on top of that now it's just a question of soldering the motor
wires and we are finished I have bring some props out now cause connect it to the
PC this updates I think I'm gonna stay with cleanfight I'm not going to change
out to betaflight because this new cleanflight out that should be really really
good I'm going to test that first before going to betaflight