Find a flat surface to place the cutter body on, a table is recommended.
Remove the end caps. Be careful with the cutter hubs, which are stored inside the end caps.
Remove the cutter from its packaging and place it on the flat table.
The parts for the stand are in a separate box beneath the cutter body. The accessories are in a box that is glued to the side.
The box containing the stand also includes the basket.
Take the parts for the standout of the box and place the basket aside for now.
Find the set of screws included in the shipping box.
Then find the Allen wrench and the screwdriver.
Take two M5 18-millimeter screws. Put a washer on each screw and
insert the screws at the bottom left and right of the horizontal support panel, giving each screw seven or eight turns.
Hook the horizontal panel in the slots in the two metal legs.
Put washers on two M5 18-millimeter screws.
Then insert the screws, with the washers, just below the two screws that are in the slots on each metal leg. Tighten the screws firmly.
Push the four wheels into the stand’s feet.
Next, mount the feet on the legs of the stand. Use a mounting plate, and four M5 60-millimeter screws with washers.
Use the 4-millimeter Allen wrench to tighten the screws into the bottom of the leg.
Then mount the other foot on the other leg, using the other mounting plate, the other four M5 60 mm screws with washers, and the 4 mm Allen wrench.
Turn the stand upright.
Place the stand close to the cutter and lock the wheels.
Locate the two pins at the top of each leg of the stand. These will help you to correctly position the cutter on the stand.
Place the cutter on the stand, and make sure the cutter is correctly positioned over the pins.
Attach the cutter to the stand using two M5 10-millimeter screws on each side. Use the 3-millimeter wrench to screw the screws in place.
Take the power cord and the LAN or USB cable and mark them at between 26 and 28 centimeters from the end.
Optional: attach the cables on the right side of the stand using three cable ties. The top cable tie should be positioned as marked on the stand.
Guide the cables through the slots in the side cover. Then attach the side cover using four PT5 10-millimeter screws and the TX20 tool.
Insert the cover caps into the slots of the other side cover before attaching it.
Insert the cover into the other side of the stand. Use the four PT5 10-millimeter screws and the TX20 tool and tighten the screws.
Mount the left and right brackets for the roll support using four M5 10-millimeter screws on each side. Use the 3-millimeter tool to tighten the screws.
Rotate the plate up and down as needed to line up the screw holes.
Slide the two guide rollers and the brake over one roll bar. Make sure the parts are lined up correctly.
Put this roll bar, and the other roll bar, into the roll bar support brackets. Make sure the brake is correctly positioned.
Gather the parts for the basket assembly.
Unroll the basket and put it on the floor.
Insert the long straight tube through the middle loop of the basket.
Insert tube “A” through the loop and across the basket at both ends.
Place the basket on the stand.
Insert the four straight tubes into the legs. To do this, make sure you rotate each tube 90 degrees in order to fit them in the holes.
Then, place tube “A” into each straight tube. Repeat this process on both sides.
Remove the blue tapes from the right side.
Push down the back lever to release the pinch wheels.
Remove the pinch wheels protection.
Remove the blade foam.
Remove the remaining blue tapes from the left side.