Required tools: All-purpose cleaning spray Fuel line pliers Crow bar Fluid container
Монтажный рычаг Ёмкость для жидкостей
1. Open the fuel door.
2. Unscrew the fuel filler cap.
3. Lift the car using a jack or place it over an inspection pit.
4. Prepare a container for fluids.
5. Clean the fasteners of the fuel supply lines. Use all-purpose cleaning spray.
6. Remove the fuel lines from the car body.
7. Squeeze the clips and detach the fuel supply lines from the fuel filter housing.
Use fuel line pliers. Use a crowbar.
AUTODOC recommends: Be careful! Fuel may leak from the filter housing and hoses.
8. Remove the fuel filter. Use a crowbar.
9. Put the old filter cartridge in the container.
10. Install a new fuel filter.
AUTODOC recommends: Make sure that the fuel filter is positioned correctly. Consider the fuel flow direction mark.
During installation, take care to prevent dust and dirt from getting into the fuel filter housing.
Take care to only use quality filters.
11. Connect the fuel supply lines to the fuel filter
12. Install the fuel lines on the car body.
13. Take the fluid container away from under the fuel filter.
14. Lower the car.
15. Tighten the fuel filler cap.
16. Close the fuel door.
AUTODOC recommends: Before starting off, switch the ignition on and off several times.
This should be done to activate the fuel pump to make it pump fuel through the fuel system.
17. Run the engine for a few minutes.
This is necessary in order to make sure that the component operates properly.
AUTODOC recommends: To protect the environment from pollution, be sure to dispose of the used filters at special collection points.