Hi everyone, Welcome back to geardo,
Today we will show you how to replace the lcd screen assembly on the Motorola Moto
G9 Play 2020 mobile phone. To start, we need to have the
right tools to proceed with the repair, which You can find in the description.
First, turn off the phone, take out the sim tray, and follows with the back cover removal.
Apply heat on the camera lens and fingerprint reader.
Next, To remove the back cover, create a gap near the sim slot
or charger port using a picker or card pry tool. Insert the card pry
tool and gently move around the phone to release the plastic clips on the frame.
Next, Hold the touch id button and pull out the back cover from the body.
Next, release adhesive strips on the frame.
Next, apply heat to the fingerprint button and gently lift the button.
Next, Take out the midframe by undoing Nine screws.
Next, Lift the adhesive and disconnect the battery plug.
Next, release the tape on the front camera.
Next, disconnect three connector plugs from the board.
Be gentle when you are disconnecting the button flex. Lift the lever and slide out the cable.
Next, undo two screws securing the board and then take out the board from the body.
Next, take out the earpiece by applying heat.
Next, take out the button flex.
Next, move to the bottom and release tapes on the cover.
Next, undo seven screws and take out the speaker cover.
Next, take out the charging port board by disconnecting the main flex plug and releasing
the antenna head from the board. It may need some heating to soften the adhesive under the board.
Next, take out the vibrator motor by applying heat.
Next, take out the battery by loosening the sides' adhesives and pulling by the tab.
Be gentle and lift the battery.
Next, move the battery protective tape to the left-hand side
and then peel the main flex cable from the body.
The only remaining part is the broken front screen assembly with the frame and buttons.
For the replacement, there are two different screen types in the market. The one is with the
frame, and the other is without the frame. It can be original, used, or aftermarket.
Either version you choose, you can get with the frame and without. But the most
straightforward repair will be with the frame, and also, the price difference is not that big.
I recommend you go with a screen with a frame & buttons installed. It can be original,
refurbished, used, aftermarket. And this type is commonly available to purchase.
Next, on the new screen frame, start placing removed parts.
First, place the button flex and secure the adhesive.
Next, place the earpiece.
Next, secure the logic board on the frame and fasten two screws on the board.
Next, secure the front camera's adhesive and connect the LCD plug and button flex to the board.
Next, place the vibrator motor.
Next, place the charging port board with the antenna to the body.
Place the antenna cable in the slot and secure the connector to the board.
Next, place and secure the main flex by connecting from both sides.
Next, place the protective adhesive back.
Next, place the battery on the body and then paste the adhesive.
Next, place the speaker cover by adding seven screws.
Next, place the adhesive strips on the cover.
Next, secure the battery plug and position the adhesive.
Next, secure the fingerprint button.
Next, Before closing the device, it is good
to verify the functionality by powering up the device.
Next, place and secure the board frame by adding nine screws.
Next, place the adhesive strips on the frame.
Finally, Snap in the back cover and run through the sides to secure the clips.
And Also, Do not forget to add the sim tray.
I
hope you have enjoyed the replacement guide.
Let us know if you have any questions; please like, share, and comment on our videos.
DO not forget to hit the subscribe button.