Hello everyone today I gonna show you how to replace camera on iPhone 7 Plus
What tools you will needed to disassemble the iPhone 7 Plus:
Screwdriver set Plastic mediator
Tweezers Suction cup for removing display
Adhesive tape for restore water protection In the description under the video, I left
links where you can buy all the necessary tools and replacement parts for the iPhone
7 Plus Turn off the iPhone and remove the SIM card
tray.
Remove the two screws near the charging port with a Pentalobe 0.8mm screwdriver
Take a hairdryer and heat the display surface for 1-2 minutes.
Set the suction cup near the home button and pull up the ring.
Next, take the plastic mediator and begin to disconnect the display from the case of
iPhone.
On the top of display, inside there are two latches that attached to the case, so you
need to pull the display down and unstick the display from top.
The case of iPhone 7 Plus opens like a book, that is, open the display to the right.
Now take a Tri-Wing 0.8mm screwdriver and remove 4 screws on the lower metal panel and
3 screws on the upper metal panel.
First, disconnect the battery cable from the mainboard and after disconnect three display
cables.
To replace the main camera on the iPhone 7 Plus, take a Standoff 1.5 mm screwdriver and
remove the screw on the metal bracket.
Next, using a Phillips 1 screwdriver, unscrew the second screw and remove the metal bracket.
Disconnect 2 camera cables from the smartphone motherboard.
Now, gently prying on the side of the camera body and remove the module from the phone
body.
In the description under the video, I left link where to buy a new camera for the iPhone 7 Plus
When you installing the rear camera, pay attention to the bend of the cables, make the installation
in the same way as I do.
Next, connect the cables to the mainboard, install the metal holder on top and fasten
2 screws.
Now you can connect the display and check how the new camera works.
Please note that first 3 display cables are connected, and lastly the battery cable.
If the smartphone is working fine, you can begin to the final stage of the iPhone 7 Plus
assembly with restoration of water resistance.
Remove the adhesive tape from the back cover of iPhone.
Now take a cotton swab and medical or isopropyl alcohol, and wipe the iPhone back cover from
the remnants of glue.
Now take a waterproof adhesive tape and put it on the iPhone case.
Using this adhesive tape, you restore resistance to dust and water.
First, connect three display cables to the mainboard of the smartphone, and then connect
the battery cable.
Install metal panels and fasten the screws.
Turn the display over and push it to the back cover.
Fasten the last 2 screws near the charging connector.
Install the SIM card and turn on the iPhone.
I hope this video was useful to you and helps repair your iPhone 7 Plus.
See you soon on HowFixit