Required tools: All-purpose cleaning spray Drive socket # 8 Drive socket # 12 Ratchet wrench
Torque wrench Vice Round-nose pliers Flat Screwdriver
Oil filter wrench Fender cover
1. Detach the connector of the water-in-fuel sensor.
2. Loosen the fastening clamps of the fuel filter pipes. Use round-nose pliers.
3. Detach the tubes from the fuel filter.
AUTODOC recommends: Be careful! Fuel may leak from the filter housing and hoses.
4. Loosen the fuel filter mounting. Use a drive socket #12. Use a ratchet wrench.
5. Remove the fuel filter. Put the old filter cartridge in the container.
6. Unscrew the bracket of the water-in-fuel sensor. Use a drive socket #8.
7. Remove the rubber strip.
8. Unscrew the water-in-fuel sensor.
9. Wait until the fuel is completely drained from the fuel filter.
10. Unscrew the clamps of the fuel filter protective case. Use a drive socket #8.
11. Remove the protective case of the fuel filter.
12. Grip the fuel filter cover with the old cartridge in a vice.
13. Открутите фильтрующий элемент.
14. Clean the mounting seat of the cartridge.
15. Screw in the new cartridge. Use an oil filter wrench.
Use a torque wrench. Tighten it to 14 Nm torque.
AUTODOC recommends: Take care to only use quality filters.
During installation, take care to prevent dust and dirt from getting into the fuel filter housing.
16. Loosen the vice and take out the fuel filter assembly.
17. Install the fuel filter protective case.
18. Tighten the clamps of the fuel filter protective case. Use a drive socket #8.
19. Remove the O-ring of the water-in-fuel sensor. Use a flat screwdriver.
20. Clean the water-in-fuel sensor. Use all-purpose cleaning spray.
21. Install the new O-ring of the water-in-fuel sensor.
22. Screw in the water-in-fuel sensor.
23. Install the rubber strip.
24. Screw in the bracket of the water-in-fuel sensor. Use a drive socket #8.
25. Install a new fuel filter.
26. Tighten the fuel filter fasteners. Use a drive socket #12. Use a ratchet wrench.
27. Attach the connector of the water-in-fuel sensor.
28. Attach the tubes to the fuel filter. Use round-nose pliers.
29. Tighten the fastening clamps of the fuel filter pipes. Use round-nose pliers.
30. Press the fuel primer pump several times until it gets hard.
31. Run the engine for a few minutes. This is necessary in order to make sure that the component operates properly.
AUTODOC recommends: To protect the environment from
pollution, be sure to dispose of the used filters at special collection points.