Hi, I’m Mike from 1A Auto.
We’ve been selling auto parts for over 30 years!
Thanks for watching.
In this video we'll be removing and reinstalling a hood latch in a 2008 Cadillac CTS 4.
If you need parts for your vehicle, click the link in the description and head over
to 1AAuto.com.
Take these pins out.
You're going to untwist them, and then once they're untwisted you can pull them up, just
like that.
Sometimes they don't untwist too well, so you got to pry up underneath it.
You can use your fingernail or a straight head screwdriver.
And then pull this panel up, and put it aside.
And then I can pull this weatherstrip towards the center of the vehicle to take it off.
Do the same with this side.
Pull up here, and pull up there.
There's a fastener right there and a clip on the back side.
I can take the weatherstrip towards the center, and this piece will come right off.
We're going to mark our latch with a felt tip marker before we take it out.
And over on this side, so that it lines up good once we put it back on once we reinstall
it.
All right, we're going to take these 10mm bolts out with a 10mm socket and a ratchet.
Take the last one out.
Next we're going to pull the cable out.
I'm going to use some needle nose pliers.
Squeeze these two tabs on the cable so that we can pull it out.
I'm going to pull it out.
Then we can pull the cable part around that way, and then pull this cable part that way.
Next we're going to disconnect this connector over here.
Try to pull it out without breaking it.
Use a clip tool there.
And then to disconnect the connector, you're going to push on this tab here and then pull,
and now your latch is out.
We're going to connect the connector.
This lets the vehicle know that your hood is open, and then you're going to push that
into where that hole was.
Now we're going to reattach the cable.
I'm going to install the cable into this slot here.
Pull it around, and then put the cable through that slot, and then insert that.
Then we're going to put our bolts back in.
Install these other two bolts.
I'm going to use our ratchet with our 10mm socket.
I'm going to try to get it lined up a little bit with our felt tip marker line.
I'm going to use this little brass hammer, sold at 1AAuto, just to tap it down a little
bit to try to get it lined up with our markings.
This side looks good.
Looks like it's all good.
Now we're going to snug them down.
Now I'm going to reinstall this shield, and we push this weatherstripping on, over like
that.
And same with the other side, just like that.
Now we're going to use these clips.
Reinstall these retainers.
I'm going to
reinstall this cover right here.
Get that lined up.
There's a little tab right there that lines up with.
Lock that down.
I'm going to reinstall this right here.
Make sure you go under the weatherstrip over here, and then press down.
I'm going to check our alignment of our hood.
Looks good over there.
Looks good over here.
Looks good.
We're going to pop our latch, then grab underneath, push up, and it works.
Thanks for watching.
Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer
service in the industry.