THIS VIDEO HAS NO AUDIO
[Installation of the HP LaserJet Managed MFP E72425-30]
[and the Y1G17A Stand]
Unbox new part as shown.
Open package of screws and put in place as shown.
Unbox new part as shown.
Remove part from machine as shown.
Place machine on base as shown.
Remove all blue tape and protective foam as shown.
Remove screw near caution sticker as shown.
Remove caution sticker.
Place screw cap where shown.
Unbox new parts as shown.
Holding cartridge horizontally, tip back and forth to mix ink.
Remove blue tape and protective foam as shown.
Unpackage new part as shown.
Remove blue tape and protective material as shown.
Remove orange tabs as shown.
Remove protective plastic from panel door as shown.
Open panel door.
Holding cartridge horizontally, tip back and forth to mix ink.
Remove orange tab as shown.
Make sure blue tab points up as shown.
Insert cartridge as shown.
Turn blue tab to the right to lock in place as shown.
Remove panel as shown.
Open side panel as shown.
Insert roller part as shown.
Screw into place as shown.
Connect cable as shown.
Close panel door as shown.
Replace panel as shown.
Close front panel.
[Upgrade firmware with the latest available on hp.com.]
[Insert a thumb drive at the connector on the control panel]
[and select the following:]
[Support Tools > Maintenance > USB Firmware Upgrade]
[Note: All accessories must be attached]
[when upgrading firmware.]
[Accessories attached later will not be upgraded automatically.]
[Find HP Online:]
[hp.com/SupportVideos hp.com/Community]
[Twitter, YouTube, Facebook@HPSupport]
[HP]