Hello I'm Happy Flyer and today I'm Going to show you how to connect your Kiss Flight Controller
and today I'm Going to show you how to connect your Kiss Flight Controller
with your Turnigy Evolution radio
we are going thru all the steps from setting it up in the kiss GUI arming it and motor calibration
Then you have a Mr Steele Drone on a budget
the first step is connecting your kiss flight controller with your Receiver in use
I'm using the TGY IA6C that came with the turnigy evolution radio
you can also use the B Version
shut have a little bit more range
Or a Flysky Receiver that weight only 1 gram
A micro receiver very small really Perfect only a little bit short on range
we have a Mod for it and all those Video's Show up over hire in the Top
the way you connect your Flight Controller
hire you have the USB Port and on top you have 1,2 and 3
the first Connection runs to PPM it's your Signal Wire
the Second is 5 volts running to the VCC
and Of Course the Third is black Going to the Ground
iff you connect that all up and you have your receiver bind to the radio
then your set to go and able to connect the Kiss Flight Controller with your PC
click connect
Going to Receiver and choose PPM Pitch throttle rudder and yaw
you can have a Quick Look at my PID's
you set the Minimal throttle to 1050
But for throttle Calibration of the motors we set the value to 2000
and press save
turn on the Quad
to Calibrate The motors you set the minimal throttle to 2000
now it's just a question of turning your radio on
and supplying your Drone with Power
beep beep beeeep
and that's Everything
just remember to disconnect your battery again iff you want to save anything to the kiss GUI
your Battery need to be disconnect it
now you can turn off the radio and we are ready to go back to the Kiss GUI to make more changes
Hire we are back at the Computer putting the value back at 1050
and press save and always double check
that's correct
now we put arming at AUX 1 High
and the Buzzer at AUX 2 on High
than we have the advanced settings but we do nothing with that
data output where you have to change to channels sub trim to set the channels at 1500
changing the Channel Value's to center them up at 1500
Go into the menu and click Sub Trim
there you can go up and down Until you see in the Kiss GUi you have center them up at 1500
Now that we are completely done with setup we armed it and did Motor calibration
we changed the throttle and channel value's to center them al up
now you're completely ready to put the props on and power up your Quadcopter and see iff she really Flies
for me AUX 2 is the Buzzer
this is the last step to arm it
better be safe than sorry
this is happy Flyer Hope you liked my Video and Like & Subscribe
Next video while be Coming Out Next Weekend... whis you all Happy Flying