Required Tools: Wire brush Nylon cleaning brush WD-40 spray Brake cleaner Copper grease
Combination spanner #12 Drive socket # 12 Drive socket # 15 Wheel impact socket #19 Torque wrench
Tap wrench Brake caliper wind back tool Crow bar Wheel chock
Unscrew the brake fluid reservoir cap.
Raise the front of the car and secure on supports.
Unscrew the wheel bolts.
Use wheel impact socket #19.
AUTODOC recommends: To avoid injury, hold up the wheel when unscrewing the bolts.
Clean the brake caliper fasteners.
Use a wire brush. Use WD-40 spray.
Unscrew the brake caliper fastening.
Use a combination spanner #12.
Spread the brake pads.
Use a crowbar.
Remove the brake caliper.
Remove the brake pads.
Use a crowbar.
Clean the brake caliper bracket fasteners.
Use a wire brush. Use WD-40 spray.
Unscrew the caliper bracket fastening.
Use a drive socket #15. Use a tap wrench.
Remove the caliper bracket
Remove the brake disc.
Clean the hub. Use a wire brush.
Treat the contacting surface. Use copper grease.
Install the brake disc.
Clean the brake caliper bracket from dirt and dust.
Use a wire brush. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
Install the brake caliper bracket.
Tighten the brake caliper bracket. Use a drive socket #15.
Use a torque wrench. Tighten it to 61 Nm torque.
Treat the brake caliper piston.
Use a nylon cleaning brush. Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
Press in the brake caliper piston.
Use brake caliper wind back tool.
Install the brake pads.
Install the brake caliper and fix it. Use a drive socket #12.
Use a torque wrench. Tighten it to 35 Nm torque.
Treat the surface where the brake disc contacts the wheel rim.
Use copper grease.
Clean the brake disk surface.
Use a brake cleaner.
AUTODOC recommends: After applying the spray, wait a few minutes.
Screw in the wheel bolts.
Use wheel impact socket #19.
Lower the car and working in a cross order, tighten the wheel bolts.
Use wheel impact socket #19. Use a torque wrench.
Tighten it to 120 Nm torque.
AUTODOC recommends: Check the brake fluid level in the expansion tank and refill if necessary.
Tighten the brake fluid reservoir cap.
AUTODOC recommends: Without starting the engine, press the brake pedal several times until you feel significant resistance.