THIS VIDEO HAS NO AUDIO
[How to Install the 2/4, 3/4 and Swedish Hole Punch Kit]
[HP PageWide Enterprise MFP P77940dn+, 785z+]
[and E77660z+ Printers]
Power machine off.
Disconnect power cord.
Disconnect cable highlighted in yellow.
Press release button as shown.
Detach cabinet as shown.
Remove screws circled in yellow.
Remove panel as shown.
Remove screws circled in yellow.
Open top cabinet door.
Remove screws circled in yellow.
Open side cabinet door.
Remove screws circled in yellow.
Open cabinet door as shown.
Remove screws circled in yellow.
Lift top panel and detach wire shown in red.
Disconnect wire shown in yellow above.
Continue removing top panel.
Remove screws circled in yellow.
Close panel door and remove as shown.
Remove screws circled in yellow.
Slide unit part out as shown.
Recycle old parts and unbox new parts.
Replace unit part as shown.
Replace screw where circled in yellow.
Connect blue cable where indicated in yellow.
Note perforated panel indicated in red.
Remove panel using flat head screwdriver.
Slide unit part into machine as shown.
Note area indicated in red and place instructions sticker.
Replace side panel as shown.
Open panel door as shown.
Replace screws where indicated in yellow.
Holding top panel upright, replace panel as shown.
Reconnect wire where indicated in yellow.
Reattach wire where indicated in red.
Continue replacing panel.
Replace screws where indicated in yellow.
Close cabinet door as shown.
Replace screws where indicated in yellow.
Close cabinet door as shown.
Replace screws where indicated in yellow.
Close top cabinet door.
Replace screws where indicated in yellow.
Replace panel as shown.
Replace screws where indicated in yellow.
Reattach side cabinet until release button clicks.
Reattach cable where indicated in yellow.
Reattach power cord.
Power machine back on.
[Find HP Online: hp.com/SupportVideos]
[hp.com/SupportForum YouTube@HPPrinterSupport]
[Facebook@HPSupport Twitter@HPSupport]
[HP]