[Music]
DJI spreading Wings s1000 Plus
installation demonstration assembling
the spreading Wings s1000 Plus open the
box install the retractable landing
gear slide a landing gear skid tube into
a landing gear
leg fasten with an M 2.5x 6.7 screw
repeat with the other leg insert the the
landing gear leg into the attachment
point on the center frame ensure the
warning sticker faces out repeat with
the other leg fasten with M 3x8 screws
install the
spring connect the large u-shaped end to
the clamp on the landing gear connect
the smaller bent end to the wire
attached to the main frame install the
frame arms ensure the propellers are in
good
condition ensure each propeller cover is
installed tightly
ensure the motors are mounted firmly and
rotate freely Mount the arms with a red
bracket to the M1 and M2 positions to
indicate the aircraft nose find the arms
with a CCW Mark Mount arms marked CCW to
the M1 M3 M5 and M7 positions on the
center frame find the arms with a CW
Mark Mount arms marked CW to the M2 M4
m6 and M8 positions on the center frame
to mount in insert each arm vertically
into the mounting area insert the screws
from the right side and tighten
appropriately gently lift the frame arm
and twist the red knob to lock it in
place repeat with all of the
arms remove the upper Center
board unscrew the four screws under the
lower Center board then remove the round
cover insert two cables into each power
bracket red cables go together into
positive brackets and black cables go
into negative brackets replace the
screws with a power CA secured
inside to ensure a reliable connection
rotate the screws until it's both tight
and parallel to the connecting
bracket put the round cover back
on make sure that all the power cables
are threaded through the holes then
replace the four
screws plug the ESC signal cables into
the slots on the center
frame next Mount the A2 flight
controller onto the s1000 plus Mount the
main
controller connect the main controller
and the center board yellow four pin
cables are for M1 to M4 connections the
yellow cable should be connected to M1
on the center board Brown four pin
cables are for M5 to M8 connections the
brown cable should be connected to M5 on
the center board black four pin cables
are for four continuous ground pin
connections connect them to the center
board then connect all of the cables to
the correspond ports on the flight
[Music]
controller attach the IMU to the center
frame with the arrow pointing towards
the
nose connect the IMU to the can1 port on
the flight controller Mount the iosd
module near the main
controller Mount the pmu module
connect the pmu power cable connect the
PW port on the pmu to the can 2 port on
the flight controller connect the iosd
power cable to the center board plug the
pmu X1 cable into the X1 port on the
flight
controller install the LED module here
we put it on the
left thread the cables through the
center frame and connect them to the pmu
attach the GPS mounting
bracket remount the upper Center board
with the GPS stand mounted tighten the
screws Mount the GPS module to the
bracket using the GPS stand ensure the
arrow on the GPS is pointing towards the
aircraft
nose connect the GPS to the can port on
the
IMU connect the iosd to the C port on
the
GPS connect the landing gears power
cable to the center board connect the F1
Port of the A2 controller to the import
of the landing
gear connect the landing gear power
cable to the power port on the center
board now install a zenmuse z15 5d3 HD
gimbal with a camera attached attach the
gimbal to the mounting bracket of the
s1000 plus plug the GCU power cables
into the respective ports connect the
GCU and iosd with the can
cable attach some velcro tape to the
battery
tray attach the battery tray and Battery
the s1000 plus uses as150 Spark prooof
Plugs connect black plugs then connect
red
plugs installation is
complete thanks for watching
[Music]