[THIS VIDEO HAS NO AUDIO]
- [Installation of the Y1G07A HP LaserJet Booklet Finisher with
Hole Punch.]
[This video shows the installation of a Booklet
Finisher with Hole Punch on an E8xxxx engine.
There are only slight differences when installing on
an e7xxxx engine, and these will be noted during the video.]
Remove strapping and open the box.
Remove any hardware, trays and accessories from the box.
Remove the device from the pallet using two people.
Hold both sides and tilt the finisher up.
Remove any tape and plastic.
Open the top cover and remove foam and tape from inside.
Remove the six screws located at the back of the device,
from the bracket.
Rotate the bracket and re-attach.
Open the front door and remove any tape.
Install the staple cartridges with arrows facing toward
appropriate orientation.
Slide back into the finisher.
Remove any screws indicated on the staple label and remove the
label.
Move the stapler into loading position by rotating the wheel
to the left.
You will notice a tab when pushing the stapler up.
Rotate the wheel to the right now to position the stapler back
at the front.
Hold the wheel and insert the stapler cartridge.
Close the front door of the device.
Rotate the device clockwise.
Remove the two screws on the side panel towards the top.
Remove the two screws and remove the unit.
Locate the tabs at the front and the brackets on the back of the
unit being inserted.
Caution with this unit.
Slide the unit into the finisher.
Connect the cables at the top.
Install a screw to secure.
Replace and screw the cover.
Rotate the device and open the front door.
Install the appropriate punch label.
Remove the perforated cover and instal the waste collector bin.
Close the front cover.
Install the brackets for the trays.
Make sure holes align with tray and bracket.
Position the tray over the bracket and push to secure.
Hold the tray from above and install screws.
Now, install the upper tray.
Install the lower tray.
Remove the duplex turnaround path and paper setting guides.
Remove the small bin actuator.
Remove the inner panel.
Remove screw covers and then remove screws.
Note: The output bin screw closer to the inner cover will
require a short and stubby screwdriver to fit.
Remove the inner cover that's upright.
Remove the upper left cover directly facing you.
Lift and pull out to remove the large output bin.
Replace the upright cover.
Note that the tab at the bottom, this inserts into the hole on
the device.
Replace the screws and screw covers.
Install the unit into the opening.
Install one screw to secure.
Remove the connector cover and install the finisher adapter
bracket with screws on the left and right side of the finisher.
Connect the finisher cables to each device.
Open the finisher front door and push the locking cover until it
stops.
Make sure it's aligned before securing with a screw.
The devices should be aligned.
If not, disconnect the finisher and access the casters to align.
Remove the booklet tray at the bottom to install the sublet
tray.
Position a box beneath.
[Find more videos like this at: hp.com/SupportVideos.
Youtube.com/HPPrinterSupport.
Continue the Conversation: hp.com/SupportForum.
Facebook.com/HPSupport. Twitter.com/HPSupport.]
[HP]