THIS VIDEO HAS NO AUDIO
[Installation of the HP LaserJet MFP E825 Products]
[and the Y1G16A HP LaserJet Department Stand]
Two people are needed to unbox.
Open the box and remove the protective foam.
Turn the box on its side, protecting the product.
Remove the product from the box.
Remove the bag from the product.
Set the product on its base.
Remove screws from bag.
Place long screws where indicated.
Place two smaller screws to the side for now.
Remove packing tape.
Pull small part out of the box.
Remove protective foam.
Remove protective cardboard.
Pull box up and away from product.
Compare product to picture on owner's manual.
Remove protective plastic.
Lift up piece as shown.
Place black handle onto machine
and screw together as shown.
Repeat for other black handle.
Remove protective foam and blue tape.
Remove orange piece.
Remove product stored within the machine.
Set to the side.
Using four people to grasp each corner,
Lift the machine up out of the plastic and set it on its base.
Continue removing blue tape.
Remove other foreign objects.
Lift up movable parts to clear foreign objects.
Open copy/scan area to remove protective material.
Close the copy/scan area and continue removing blue tape.
Check in the belly of the machine to remove debris.
Unscrew and remove black handles.
Open top-most paper tray to remove foam and tape.
Continue removing foam and tape in remaining paper trays.
Remove plastic from HP logo.
Open top-most paper tray and remove from product.
Remove middle paper tray.
Place small screws where indicated above.
Tighten firmly.
Using a magnetic Phillips-head screwdriver,
Remove the screw where indicated above.
Remove red caution sticker.
Place screw cap where indicated above.
Open front cabinet door from top to bottom.
Remove orange piece by grasping tab as indicated.
Set to the side.
Grasp the bottom red tab and remove piece as indicated.
Set to the side.
Grasp top red tab and remove piece as indicated.
Remove protective tape from bottom of part as shown.
Remove protective tape from top of part as shown.
Shake part.
Insert part into cavity as shown.
Toggle handle to the left.
Note area indicated in red.
Notice it move as you open the side cabinet door.
Open package that was set to the side earlier.
Remove roller unit.
Unfold bag flat and open.
Notice edge where indicated.
Grasp part from bottom and pry up edge as shown.
Remove orange casing.
Grasp roller unit with handle as shown.
Insert roller unit into machine cavity as shown.
Note where the top of the roller unit
slides into the machine cavity.
Push roller unit into the machine until it is secure.
Note loose screw and hand-tighten it.
Place black panel cover as indicated above.
Push in firmly to secure it.
Close the machine front door.
Close the side cabinet door.
Note serial number and product name indicated in red above.
[Upgrade firmware with the latest available on hp.com.]
[Insert a thumb drive at the connector]
[on the control panel and select the following:]
[Support Tools > Maintenance > USB Firmware upgrade]
[Note: All accessories must be attached]
[when upgrading firmware.]
[Accessories attached later]
[will not be upgraded automatically.]
[Find more videos like this]
[at hp.com/SupportVideos youtube.com/HPPrinterSupport]
[Continue the conversation: hp.com/SupportForum]
[facebook.com/HPSupport twitter.com/HPSupport]
[HP]