[Music]
[Applause]
[Music]
[Applause]
hello guys is Glen from Sydney CBD or
Paris Center and today we have an Apple
watch series 444 millimeters with a GPS
so this is a new the new version of the
Apple watch is the fourth-generation
obviously this is a series 4 and the
client brought this in to us with not
really that bad screen damage it was
just shattered on the corners and we are
going to replace it so apparently the
Apple watch is not really immune to
breakage the sapphire crystal on top is
resistant to scratches but not to
breakage so as long as you're really
careful with your Apple watch do you
don't have to worry about the breakage
if the baby use may be maxing mostly on
scratches but not really on the
possibility of it breaking up on you
so we we are just going to slowly take
your time and remove the front glass so
just like the smartphone the Apple watch
uses a backlight an LCD combo that is
attached by flat cables through these
three connectors so we're just going to
peel off the insulation and detach it
and pull it out so if you re going to
replace only the screen of the Apple
watch it is a direct replacement no need
for us to remove the internals and the
buttons underneath it we're just going
to clean up the old adhesive as usual
obviously this doesn't require any
screws and the adhesives is the main
attaching medium of the glass to the
main assembly
so the old adhesive will not be
effective now in deflecting water in
from entering so we're going to replace
it with new adhesives so in Sydney CBD
repair center we have stocks of Apple
watch series for replacement screens and
right at the right side of the this one
is the new one that we are going to
directly you install through these three
connectors it is a straightforward
operation just be careful not to scratch
or as you open the device you don't want
to snap off the these flat cables if you
do then that would be an even more
expensive repair so it if you want to
DIY this just be bear that in mind if
you don't want to ruin your good Apple
watch you just want to replace it just
contact a professional take it to us and
Sydney CBD repair Center give us a call
we'll give you the replacement screen
we'll do the replacement service for you
and we're going to give you a quality
replacement part so we're going to test
it now going to turn it on if it works
if there's an any issues with booting up
then we may be in for a very long repair
session it may be a issue with the
battery or the board itself inside
so there it is it's working and you can
see the the keypad is working it's
responding to touch and swipe so this is
not yet stuck in the main assembly the
adhesives were not yet installed we're
just testing it out and we are going to
apply a special adhesive just to keep
the Apple watch waterproof so the
obviously this is not a factory
replacement of the adhesive so you might
still consider being more careful with
your Apple watch
so this moderns smartwatches is not
really the same as your pro divers the
traditional watches that you have on
your wrist so you might want to refrain
from swimming with it his splashes is
okay so we're going to clamp it set the
adhesives and then come back and do the
final testing we're going to attach the
watch bands so if you have defective
iPhones Apple watch
just take it Sydney CBD repair Center
will do everything for you we have the
stocks of replacement screens we'll do
the replacement repair we'll test it for
you we ensure that your smartphone is is
taken care of all throughout the repair
procedure so it won't be scratched up
when you receive it so this one is a
success it's ready for delivery and like
and subscribe to our Channel if you have
any questions leave a comment down below
like our page
give us a call if you want to have your
own repair service schedule so next time
guys Cheers
[Music]