LSL titan damper should be repaired when there is too mane air or oil is too old
LSL supplies repair kit, so you can rebuild damper yourself
In this case there is an air in the system, so you can feel it moving the rod
First remove adjusting knob
Next remove stop rings from both sides
Remove oil seal from mount side
Remove mount from the rod
Now the rod can be pushed through another oil seal to remove it
Next disassemble adjusting mechanism
Clean all parts with kerosine
Here are all parts of the damper
New seals, stop rings, pin and adjusting mechanism are used from repair kit
Assemble adjusting mechanism in the following sequence
Adjustment is carried out by rotation of the flap which overlaps the hole
Connect two parts of the rod by clip
First install bush, seal and stop ring from mount side
Next fill the damper with oil
We use fork oil 15W
Install the rod carefully not to damage the oil seal
The dumper can overfill with oil.
Push the rod slowly to remove air
Add oil if it’s necessary
Install bush and oil seal
It’s not possible to set oil seal in place, as there is too much oil
Push the oil seal with old oil seal lower the tube’s edge and set the stop ring
Next push the stop ring with oil seal together until they sit in place
Such method allows to build damper without air
Check the adjusting mechanism and air in the damper
Next install adjusting knob and mount
Clean the damper
Subscribe, if information was interesting!