THIS VIDEO HAS NO AUDIO
[Installation of the 2nd Exit and Finisher Bridge]
[on the HP LaserJet MFP E7 Products]
[Note: The 2nd Exit Assembly]
[comes pre-installed on the E8 series.]
Open side cabinet door as shown.
Remove screw caps indicated in red above.
Remove screws with magnetic Phillips-head screwdriver.
[Push the front panel slightly forward to release side cover]
[Remove the two caps and two screws]
[on the power button cover.]
Use a magnetic Phillips-head screwdriver.
[Rotate cover forward until frame is exposed.]
[Remove one screw and remove the 2nd Exit dummy cover.]
[Remove paper settling guides from 1st Exit.]
Notice how it bends.
[Lift the hook and remove the bin full actuator.]
[Note: Remove the bin full actuator]
[if installing an inner finisher or bridge.]
[Leave the bin full actuator installed]
[only when the face-down output bin will be used.]
Note areas circled in red.
[Remove two caps and two screws.]
Note of caution here.
You will need a shorter screwdriver.
[Remove small cover on left.]
[Remove output bin.]
Remove blue tape from unit as shown.
[Release the hook and remove the 2nd Exit bin full actuator]
[Note: The 2nd Exit bin full actuator is only required]
[if an Inner Finisher or a Job Separator are installed.]
[For Bridge Installation, the actuator has to be removed]
[Align the pin with the hole when installing.]
Note areas highlighted in red above.
[Install two screws.]
Circled in red above.
[Connect three cables.]
Indicated in red above.
[Replace the upper right cover.]
Replace screws as shown.
[Snap the power button cover back into position]
[and install one screw.]
Replace screw caps.
Close cabinet door.
[Re-install two screws]
[on the left side of power button cover.]
Replace screw caps.
[Install the bridge for the finisher.]
[Verify the pin is correctly aligned with the hole.]
[Install one screw to secure bridge to the device.]
Circled in red above.
[Find more videos like this]
[at hp.com/SupportVideos youtube.com/HPPrinterSupport]
[Continue the Conversation: hp.com/SupportForum]
[facebook.com/HPSupport twitter.com/HPSupport]
[HP]