Push the end cap up fully and pull the brush bar out of the cleaner head.
Remove the end cap and set aside, don't wash it.
Hold the brush bar under tap water and gently rub to remove any lint or dirt.
Remove as much excess water as possible.
Stand the brush bar upright and leave for at least 24 hours to dry.
Make sure your brush bar is completely dry before refitting.
Reattach the end cap.
Using a clean dry cloth, wipe clean the head and the illuminaton.
Take care to align the end cap correctly. Position at a 45 degree angle, otherwise it cannot be pushed down into place.
Hold a lint-free cloth under water to dampen.
Wring the cloth to remove excess water.
Wipe all other tools with a damp cloth only.
Make sure all tools are completely dry before using.
Remove the filter unit by twisting anti-clockwise.
Gently tap the filter unit to remove any excess dust and debris, before washing it.
It's important to wash the filter with water only.
With the foam element downwards, run water over the pleated paper and then the inside of the foam element.
Hold the filter on its side, and run warm water over the outside of the foam element, gently rubbing to remove the dirt.
Repeat washing until the water runs clear.
Shake the filter unit to remove any excess water,
and leave for at least 24 hours to dry, in a warm place with plenty of airflow.
Check the filter is completely dry before refitting, or it could damage the motor.
To refit, twist the filter unit clockwise until it secures into place.
Empty your bin before the dirt reaches the MAX line.
Hold your machine over the bin pointing downwards. Firmly push the red release lever.
Press the red button to release the bin and slide down to remove.
Dampen a lint-free cloth.
Wring to remove excess water.
Wipe the bin clean with the damp cloth.
Make sure that all parts of your bin, including the rubber seals, are completely dry before refitting into your machine.
To refit, slide the bin back onto its runner.
Close the lid and push to click the bin and base into place.