THIS VIDEO HAS NO AUDIO
[Installation of the HP LaserJet Department]
[Job Separator (Y1G01A)]
[HP LaserJet Managed MFP E825xx]
[HP color LaserJet Managed MFP E876xx]
Lifting the cover flap, power down the machine.
Unplug the device.
Note screw caps indicated in red above.
Remove them by prying up a small screwdriver.
Remove the screws.
Remove the housing panel.
Note screw caps indicated in red above.
Remove screw caps.
Remove screws using magnetized screwdriver.
Remove output tray.
Note screws and screw caps indicated in red above.
Remove screws and screw caps.
Remove side panel.
Punch out perforated rectangle on the panel using your thumb.
Unpackage new job separator.
Note small parts taped to styrofoam.
Remove black bracket from machine.
Note areas indicated in red.
Insert new parts to places where indicated previously.
Screw part to machine where indicated in red above.
Note connector wire indicated in red above.
Connect to machine.
Replace panel, lining up screw holes.
Replace screws where indicated in red above.
Note screws circled in red above.
Replace screw caps where indicated.
Tuck connector wire as indicated.
Place output tray.
Note screw holes indicated in red above.
Replace screws.
Note screw holes indicated in red above.
Replace screw caps.
Note areas indicated in red above.
Attach tray to machine at indicated areas.
Attach tray to machine where perforated area was punched.
Attach screw where indicated.
Replace white panel as indicated above.
Note areas indicated in red above.
Replace screws as shown.
Note screw holes indicated in red above.
Replace screw caps where indicated.
Replace power cord.
Power the machine on.
[Find HP Online: hp.com/SupportVideos]
[hp.com/SupportForum YouTube @HPPrinterSupport]
[Facebook @HPSupport Twitter @HPSupport]
[HP]