- Hey, this is Donny Smith.
In this video, we're working the Mustang project
and we're gettin' this quarter panel finished up.
Now what I'm gonna do is there's this edge here.
Now, normally there is an edge
where you put seam seal over it,
but it's usually the nose from the factory.
What we're gonna do is...
We've already got 8115 when we installed the quarter panel,
but I've sanded it smooth down to metal
and what we're gonna do is put some more 8115.
So I have some 8115,
and what that is, that is a panel bond
that you use for puttin' the panel on.
There's different ones.
Just 8115 is 3M brand.
There's other brands, though.
So I wanna apply here and then when I'm done,
I'm gonna sand that,
so you won't even know that there was a seam here.
I'm gonna do the same thing down here
like I mentioned in the update video.
From the factory, you can see all these,
so if you're really going for that stock factory look,
I wouldn't do this.
We gonna go ahead and fill some of these in.
You wanna put a bead up here.
(upbeat music)
And 8115, it's pretty slow dry,
so you've leave time to work it.
Now what I'm gonna do is
I'm just gonna take the spreader and spread it out
and that will help spread over evenly
and also, it will help reduce the amount of sanding
that I have to do.
(upbeat music)
And this doesn't have to be prefect
cause we're gonna sand it.
The smoother you get it,
the less sanding you'll have to do.
(upbeat music)
I've got a little bit left on my spreader,
so I'm gonna go ahead and use that, start using that up.
I'm gonna spread a little bit more.
And just put it right in the seam.
(upbeat music)
Might as well fill this weld location up with it.
This is pretty good stuff.
It seals really good.
It's not on the cheapest side, really.
I mean it's probably more expensive than fiberglass.
(upbeat music)
Okay, I've got this on.
We'll let that dry and then we'll sand it.
We may need to put a little bit more, sand it,
and you can also put body filler over this once it's sanded.
Not going to video it all,
but also I've welded this on here.
We're gonna go ahead and put a coat on here
to fill in any gaps or pin holes,
anything like that just to seal it up real good.
You could do that with fiberglass, also.
Probably a little less expensive, but we're gonna go ahead
and use this 8115 on that.
Alright, we have this applied.
We're gonna allow it to dry and then we'll get it sanded.
Thanks for watching this video.
If you like it, be sure and give us a thumbs up
and we'll talk to you in the next video.
Hey, before you go anywhere be sure
and check out some of my other videos and playlist.
(tech music)