[THIS VIDEO HAS NO AUDIO]
[HP]
Installation of the Y1G20A HP LaserJEt 3000 Sheet HCI.
Open the box and remove the packaging.
Remove the accessories from the plastic.
Notice the butterfly screws.
And also the metal latches.
Set aside.
Remove the plastic covers.
Take the first layer with accessories packaged in it and set aside.
You will need two people to flip the box so printer can lay on its side.
Remove the plastic from the printer.
Place the 3000 sheet HCI right side up.
Remove all the packaging.
Open the top tray and remove foam pieces.
Push on the tray until it goes all the way to the bottom.
Remove the plastic sheet on the side.
Notice the screws in the corners next to the cover.
Using your index finger pinch the latch to remove the cover on the width side.
Repeat the process on the other side.
Notice the 2 small placements where the cover was.
Using a screw driver unscrew the green screw next to the placements.
Pull the metal sheet out from the side.
Using your other hand push the tray down.
Insert the metal sheet in the slots to insert it properly.
Release the tray to let it bounce up properly.
Place the screw back in.
Repeat the process on the other side.
Place the screw back in and secure.
Look at the screws at the top.
Unscrew them all.
Push the tray down again
Remove the metal bars and place in the next slot towards the center.
Repeat the process on the other metal bar.
Release the tray.
Place the screws back in all placements.
Place the covers back on the sides.
Close the top covers.
Remove the placement covers on the front bottom tray.
Remove all the screws.
Open the tray.
Close it back up.
Remove the tray cover.
Notice the placement impressions on the inside of the cover.
Now place the metal latches in the corner and secure with screw.
Repeat the process on the other side.
Add the metal stopper to the metal rail.
Note: The rail CAN be installed upside down, but this requires a lot of force to push by the grounding clip.
Slide the metal rail into the metal stopper.
Align the rail and stopper under the printer.
Notice the big metal peg in the middle.
Screw the stopper to secure it at the bottom of the printer.
Attach the cover back on, align the metal latches and peg with the slots on the cover.
Remove the dotted out impressions from cover.
Use a screwdriver to help push it out if needed.
Align the popped out holes with the accessories sticking out.
Secure it with screws.
Pop out the plastic slot cover.
Remove the impression so there is a hole slot in the middle of the cover.
Place it back on.
Now lift the 3000 sheet HCI to the metal rail.
Use the butterfly latch to secure on the rail.
Now screw it in.
Plug the cord into the printer port.
Now slide it all the way back.
Be sure the two devices align.
Pull it away to spin the spacers and verify they are installed correct.
Push the HCI back into the printer.
Find more videos like this at: hp.com/SupportVideos, youtube.com/HPPrinterSupport.
Continue the conversation: hp.com/SupportForum, facebook.com/HPSupport, twitter.com/HPSupport.
[HP]